Durkopp Adler D888 handleiding
Handleiding
Je bekijkt pagina 143 van 264
Programming Commander DELTA
Operating Instructions D888 e-con - 00.0 - 12/2023 141
5.9.5.4 Setting the Correction speed effect parameters
Some parameters are affected by high speeds because of
the resulting physical effects. To counteract these effects and
to achieve consistent results, even at high speeds, adjustment
factors can be set depending on the speed.
Overview of setting modes
The correction of the effects of high speeds can be identified in
various modes and responded to depending on the setting.
This general explanation can be applied to the following specific
parameters.
Setting mode Description
Linear In the linear setting, the size of the parameter
increases or decreases steadily as the speed
increases. The increase/decrease of the parameter
depends on the limits set for the minimum and
maximum speed.
2. Value
On/Off
If a certain speed is exceeded, the second value
of the parameter is activated. If the speed then falls
below this level again, it switches to the base value
for the parameter.
2. Value On If a certain speed is activated, the second value of the
parameter is activated. If the speed then falls below
this level again, it does NOT switch to the base value
for the parameter. Only after finishing the seam by
cutting the thread is the base value for the parameter
set again.
Bekijk gratis de handleiding van Durkopp Adler D888, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D888 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 27738 MB |
