Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 140 van 286
Programming Commander DELTA
138 Operating Instructions D867 e-con - 00.0 - 06/2023
5.10.5.2 Setting the Bobbin monitor mode parameters
The amount of remaining thread on the bobbin can be monitored
optically or by software using this setting.
Menu item Setting 1 Setting 2
Off Sewing stop
Sewing stops and a notice is
shown on the display when
the bobbin is detected to be
nearly empty. If the parameter
is not activated, only the
LEDs on the machine arm
give a warning if the bobbin is
empty.
Value range
On/Off
Sewing foot lower
position
Value range
On/Off
Software /
Stitch Counter
In Software mode,
the bobbin is moni-
tored by the software
based on the num-
ber of stitches sewn.
Counter Type
4 different counters can be
applied. The following 3 sub-
items can be set for each of
the counters.
Value range
A/B/C/D
Counter value
Bobbin supply capacity in
stitches. This is a very variable
value, which depends on the
size of the bobbin and the
thickness of the thread.
Value range
00000 - 99999
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
