Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 111 van 286
Programming Commander DELTA
Operating Instructions D867 e-con - 00.0 - 06/2023 109
5.8.3.3 Setting the Correction speed effect
parameters
Some parameters are affected by high speeds because of
the resulting physical effects. To counteract these effects and
to achieve consistent results, even at high speeds, adjustment
factors can be set depending on the speed.
Overview of setting modes
The correction of the effects of high speeds can be identified in
various modes and responded to depending on the setting.
This general explanation can be applied to the following specific
parameters.
Setting mode Description
linear In the linear setting, the size of the parameter
increases or decreases steadily as the speed
increases. The increase/decrease of the parameter
depends on the limits set for the minimum and maxi-
mum speed.
2.On/Off If a certain speed is exceeded, the 2
nd
value of the
parameter is activated. If the speed then falls below
this level again, it switches to the base value for the
parameter.
2.On If a certain speed is exceeded, the 2
nd
value of the
parameter is activated. If the speed then falls below
this level again, it does NOT switch to the base value
for the parameter. Only after finishing the seam by
cutting the thread is the base value for the parameter
set again.
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
