Durkopp Adler 550-D869-100 e-con Handleiding (198 Pagina's)

Handleiding

Je bekijkt pagina 89 van 198

Programming Commander DELTA

Instructions for use 550-D869-100 e-con - 00.0 - 01/2025 87

5.7.3.2 Setting the Correction speed effect parameters

Some parameters are affected by high speeds because of the

resulting physical effects. To counteract these effects and to

achieve consistent results, even at high speeds, adjustment

factors can be set depending on the speed.

Overview of setting modes

The correction of the effects of high speeds can be identified in

various modes and responded to depending on the setting.

This general explanation can be applied to the following specific

parameters.

Setting mode Description

Linear absolute In the linear absolute setting, the size of the

parameter increases or decreases steadily as the

speed increases. The increase/decrease of the

parameter depends on the limits set for the

minimum and maximum speed.

Linear with offset In the linear offset setting, the size of the parameter

increases or decreases steadily as the speed

increases. The increase/decrease of the parameter

depends on the limits set for the minimum and

maximum speed and on the offset value.

2. On/Off If a certain speed is exceeded, the 2

nd

value of the

parameter is activated. If the speed then falls below

this level again, it switches to the base value for the

parameter.

2. On If a certain speed is exceeded, the 2

nd

value of the

parameter is activated. If the speed then falls below

this level again, it does NOT switch to the base

value for the parameter. Only after finishing the

seam by cutting the thread is the base value for the

parameter set again.

Bekijk gratis de handleiding van Durkopp Adler 550-D869-100 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.