Dreame V11 Pro handleiding
Handleiding
Je bekijkt pagina 15 van 51
5
EN
Installing the Cyclone
Assembly, Filter, Built-in
Sponge and Dust Cup
1. As shown in the picture, press the brush
roller release button to remove the roller
from the slot.
2. Separate the roller from the side cover.
Turn the small wheel release buttons
counterclockwise to remove the wheels.
3. Use scissors to cut o the hairs and
bers that get stuck on the brush roller and
the wheels. Wipe the dust from the notch
and transparent cover with a dry cloth or
paper towel. Thoroughly dry before use.
4. When it is dirty, rinse the brush roller
with clean water until it is clean. Then
stand the brush roller upright for at least
24 hours until it is fully dry.
• Install the cyclone assembly, sponge
and pre-lter into the dust cup.
Fig. E-5
• Slightly tilt the dust cup so the slot aligns
with the clip on the vacuum. Then gently
push the dust cup until it clicks into
place.
Fig. E-6
Fig. E-4
• Rinse the cyclone assembly, lter,
sponge, and dust cup until they are
clean. After washing, air dry for at
least 24 hours.
Note:
1. It is recommended to clean the dust
cup after use.
2. It is recommended to clean the
cyclone assembly and sponge at least
once every 3 to 4 months, the lter
once every 4 to 6 months.
3. Only use clean water to wash the lter.
Do not use detergent.
4. Do not attempt to clean the lter with
a brush or nger.
Cleaning the Soft Roller
Brush
Fig. E-7
Fig. E-8
Fig. E-9
Fig. E-10
Bekijk gratis de handleiding van Dreame V11 Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dreame |
| Model | V11 Pro |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 6757 MB |
