Drawmer MQ-2 handleiding
Handleiding
Je bekijkt pagina 10 van 13
10
DRAWMER
CRUSH On / O
Adds a xed time constant, auto gain makeup compressor and introduces some
musically pleasing harmonics to all of the EQ bands.
The Crush button is applied to frequencies that are boosted and not those that are cut,
and so it’s eectiveness will vary depending on the frequency, the amount of boost
applied and also on the instrument that it is applied to. Use it in the lower frequencies
to fatten up the kick, tom or snare drums, bass guitar and other elements of the rhythm
section. In the mid frequencies it will help to warm the mix and enhance the presence.
It will thicken the guitars and add punch to the percussion, increase the attack of a
piano, as well as help to bring out the raspiness in a vocal, for example. At the high
frequencies it will bring out the shimmer of cymbals and brighten the string instruments.
The eect is progressive, so as more boost is added to the band the CRUSH eect is
more apparent. If you wish to apply much more boost to a band in order to obtain more
‘crush’ the GAIN control can be used to reduce the levels should the signal reach the
rails. Use the switch to listen to A/B comparisons to hear the eectiveness of the feature.
GAIN +14 to -14dB
Adjust the Output Gain control to the required output level using the meter above as
a guide. If you require more crush drive the Eq and Compressor harder then back o
to the required output level using this control.
ORDER COMP>EQ / EQ>COMP
This switch allows the signal path to either route through the EQ rst or the compressor
rst, as each way creates a distinctly dierent tonal quality, and colouration depending
on the setting.
Note: A slight pop occurs when swapping the EQ and Compressor in the audio chain so it is
recommended to reduce the gain whilst swapping.
BYPASS Switch
With the Bypass switch active the input signal is routed to the output with no signal
processing taking place. Use it to provide A/B comparisons.
G.R. METER -1 -2 -3 -5 -7 -10 -15 -20 dB
An eight segment LED bargraph meter continuously monitors the gain reduction applied
by the compressor over the range 0 to 30dB.
LEFT & RIGHT V.U. METER -20 -15 -10 -5 0 +5 +10 +15 dB
Two 8 segment LED bargraph level meters for the Left & Right level of the output
signal over the range -20dB to +15dB.
USEFUL FREQUENCIES
Bekijk gratis de handleiding van Drawmer MQ-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Drawmer |
| Model | MQ-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2712 MB |
