Drawmer MC2.1 handleiding
Handleiding
Je bekijkt pagina 6 van 24
6
DRAWMER
INSTALLATION
The MC2.1 is a free standing, desktop unit, with controls and headphone jacks on
the front panel and all other inputs and outputs on the rear. Multiple units can be
stacked whilst sitting on the desk, however, the MC2.1 can be screwed to the desk
or into a standard 19” rack (using a 2U mounting kit).
Note that whether fixing to a desk or to a rack the speaker trims on the base of the
unit will not be accessible and so the calibration procedure should be carried out
before fastening the MC2.1 in place (see ‘Monitor Calibration’).
Screwing the MC2.1 to
a desk.
Rather than having the
MC2.1 free standing it
can be fastened down to
a desk by utilising the
holes that hold the
rubber feet to the
underside.
Drill four holes into the
desk, at 4mm in
diameter and to the
dimensions as shown in
the diagram. (Note that
the diagram is viewed
from above).
Pushing four screws
through the under-side
of the desk screw the
MC2.1, including the
rubber feet, to the panel
to secure. The screws
should be M3 and have
a length of 14mm plus
the thickness of the panel.
Bekijk gratis de handleiding van Drawmer MC2.1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Drawmer |
| Model | MC2.1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6059 MB |
