Draper D20 55771 handleiding
Handleiding
Je bekijkt pagina 7 van 8
–
7
–
ventilated during tool operation. Avoid blocking the air
inlets and vacuum the ventilation slots regularly.
9. BATTERY
9.1 BATTERY PACK CHARGING –
FIGS. 6 – 7
Important! Draper designated battery packs and
chargers must only be used with this product. Use of any
other third-party battery packs/chargers is considered
misuse and will invalidate the warranty.
Once connected to the mains supply, recharging of the
battery can be left generally unsupervised.
Warning! Check the condition of the charger and
battery prior to each charge. Do not use if there is any
sign of damage.
The battery pack is supplied un-charged and must be
charged before initial use.
To charge the battery pack (15):
– Plug the battery charger (14) unit into a suitable
mains power supply socket.
– The red LED (14.1) will illuminate to show the
charger has power.
– Slide the battery into the charger’s aligning pins.
– After a few seconds delay, the red LED will flash to
show that charging has begun, then changes to solid
red.
– Whilst the battery is charging, the green LED (14.2)
will flash.
– When the battery is fully charged the green LED
stops flashing and changes to solid green. The red
LED will turn off.
6
FIG.
(14.1)
(14.2)
(15)
(14)
To release the battery pack:
– Press the battery release button (15.1) and gently
slide the battery pack off.
7
FIG.
(15.1)
Caution: Only use the plug to disconnect from the
power supply, never use the cable.
Caution: If the battery charger has been in continuous
use it will be hot. Once charging is completed, leave the
charger to cool.
Only charge cooled batteries.
9.2 BATTERY PACK PROTECTION
FEATURES
Overcharging protection: When the battery pack is
fully charged, the transformer/charger will automatically
shuts off, protecting the internal components.
Over-discharging protection: Stops the battery pack
from discharging beyond the recommended lowest
safety voltage.
Overheating protection: An internal thermistor cut-off
sensor shuts off the battery pack should it become too
hot during operation. For example, if the tool is
overloaded or used for extended periods. 30 minutes
cooling time may be required.
Current protection: If the battery is overloaded or the
maximum current draw exceeded, the battery will shut
off to protect internal components. The battery pack will
resume operation once the current draw is at a safe
level.
Short circuit protection: The battery pack will stop
operating immediately if it was to short circuit.
Bekijk gratis de handleiding van Draper D20 55771, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | D20 55771 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 1689 MB |
