Draper D20 08096 handleiding
Handleiding
Je bekijkt pagina 19 van 22
10. MAINTENANCE AND TROUBLESHOOTING
– 19 –
10.6 CLEANING THE SPRAY HEADS
If the nozzle becomes plugged, use the steps below to clear.
− Remove the battery pack.
− Unscrew and remove the spray head from the spray lance.
− Push a small wire through the cross holes to clear any debris. If necessary, rinse the cross
holes and nozzle with clean water.
− Wipe the nozzle and cross holes with a clean dry cloth and re-install the nozzle.
10.7 REPLACING SEALS
WARNING: Always follow procedures for draining and cleaning the tank before replacing the
seals. Make sure you wear rubber gloves when reaching into the chemical tank. Wash your hands
thoroughly afterwards. Failure to follow these instructions can result in a rash, skin irritation, or
other serious personal injury if you directly contact some chemicals.
Over time, seals can harden and crack, which can allow the chemical sprayer to leak. A set of
replacement seals is included. Refer to the image shown for the location of each of the seals,
then replace as needed to address any leaks that develop.
NOTE: Threading the connections to replace the seals could allow liquid to escape, so always
clean the chemical sprayer thoroughly as previously described before replacing the seals.
10.8 STAORE THE SPRAYER -
FIG 18
After cleaning, store the sprayer in a dry
place, do not put the sprayer in the sun.
The sprayer lance can be put on the hang
hook, or put on the tank cap. See g. 14.
18 FIG.
Bekijk gratis de handleiding van Draper D20 08096, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | D20 08096 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3102 MB |
