DoorBird A1122E handleiding
Handleiding
Je bekijkt pagina 6 van 72
6
THIS SIDE UP
. DISASSEMBLING THE FRONT PANEL
Remove the front panel with the attached Main Electrical Unit carefully from the mounting housing (backbox)
using the orange (Torx+Pin) screw driver provided.
We have designed the front panel and the safety screw in a way that it cannot be screwed through the
front panel so that is does not fall off / get lost during installation..
Turn the safety screw counter-clockwise until it is loose. Pull the front panel with attached Main
Electrical Unit out of the mounting housing (backbox).
Flush-mounted model Surface-mounted model
ASSEMBLING THE MOUNTING HOUSING
The product is available as a surface-mounted and flush-mounted version. In the flush-mounted version, the
front panel is slightly larger to better cover the hole in the wall, and the mounting housing (backbox) is made
entirely of metal instead of plastic.
68,00 mm
2.68 in
138,00 mm
5.43 in
26,50 mm
1.04 in
68,00 mm
2.68 in
138,00 mm
5.43 in
26,50 mm
1.04 in
If you must drill holes in a wall, insert screws into a wall or lever up a wall, ensure that no cables or mains
(gas, water, etc.) are to be found in the wall.
If the wall of the house is made of wood, dowels are not normally required. There are special dowels for
assembling the device on an insulating wall, e.g. Fischer insulating dowels.
If you use the flush-mounted housing, lever up the
wall accordingly.
Flush-mounted model
If the wall of the house is not made of wood, you
should drill dowel holes 5 mm (0.19 in) in diameter
in the wall according to the drilling template and
then place the dowels provided into the boreholes.
Bekijk gratis de handleiding van DoorBird A1122E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DoorBird |
| Model | A1122E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8592 MB |
