Dirt Devil SD66000 handleiding
Handleiding
Je bekijkt pagina 2 van 18
ASSEMBLY
Fully assemble product prior to use.
TOOLS NEEDED
SEE FIGURE 1.
The following tool (not included or drawn to
scale) is needed for assembly:
Phillips head screwdriver
LOOSE PARTS LIST
SEE FIGURE 2.
Vacuum Assembly.....................................................1
Handle ........................................................................ 1
Caster .........................................................................4
Hose ............................................................................1
Extension Wand .........................................................2
Cartridge Filter ..........................................................1
Filter Retainer ............................................................1
Foam Wet Filter ......................................................... 1
Crevice Tool ................................................................1
Utility Nozzle ............................................................. 1
Floor Brush/Squeegee Nozzle ................................. 1
2 Screws (Bag) ..........................................................1
Operator’s Manual .....................................................1
NOTE: The hose and accessories for this vacuum
are 1.25” (31.2 cm) diameter.
WARNING: Do not plug the power
cord into a power outlet. Make sure the plug is
disconnected before assembling the wet/dry
vacuum. To reduce the risk of electric shock, do
not expose to rain.
UNPACKING YOUR WET/
DRY VACUUM
1.
Verify that the power cord is disconnected from
the outlet.
2.
Undo the latches. Lift the power head o the
collection tank.
7
8
9
10
6
5
1
2
3.
Remove the contents from inside the collection
tank; make sure you have all contents as listed.
ATTACHING THE CASTERS
Turn the collection tank upside down and insert
the four casters into the slots on the collection
tank. Inserting the casters may require some
force; tap with a rubber mallet to ensure they are
pushed in all the way. Verify that the casters are
mounted correctly.
ATTACHING THE HANDLE
Attach the handle into the slots located on the
top of the power head and secure with supplied
screws.
INSTALLING THE
CARTRIDGE FILTER
Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not installed,
refer INSTALLING CARTRIDGE FILTER for
installation instructions.
INSTALLING THE DUST
COLLECTION BAG
DUST BAG AVAILABLE SEPARATELY.
OPTIONAL: For improved dust filtration, fit the
dust bag flange onto the inlet port, taking care
not to damage the bag.
INSTALLING THE FOAM
WET FILTER
For wet vacuum cleaning, remove the cartridge
filter, and install the supplied foam wet filter.
ATTACHING THE POWER HEAD
Place the power head back on the collection tank
aligning the top section with the latches, and
snap into place.
ATTACHING THE HOSE
Insert the locking end of the hose into the
vacuum port of the collection tank and turn
clockwise to lock into place.
INSTALLING
ATTACHMENTS
Choose the desired attachment and insert onto
the end of the hose or extension wand.
POLARIZED PLUG
To reduce the risk of electrical shock, this
appliance has a polarized plug (one blade wider
than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
Double
insulation eliminates the need for the
three-wire grounded power cord and grounded
power supply system.
Bekijk gratis de handleiding van Dirt Devil SD66000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dirt Devil |
| Model | SD66000 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 5662 MB |
