Handleiding
Je bekijkt pagina 40 van 56
EN-12 2202/D www.dimplex.eu
English Electrical connection
7. Electrical connection
NOTE
i
When connecting the storage heater to the power
supply, the relevant VDE, EN and IEC standards must
be observed. The technical connection conditions of
the energy supplier or grid operator must be complied
with.
7.1 Unscrew the securing screw (A) and fold the main
electronics down (B) to access the connecting termi-
nals.
Insert the electrical connecting lines and provide
strain relief. (C). Shorten the lines so that they do not
touch any hot device surfaces during operation. Do
not route any cable loops behind or below the device!
NOTE
i
When folding up the main electronics into the vertical
position, ensure that no lines are trapped.
Establish the electrical connection according to the
circuit diagram. Circuit diagram and connecting ter-
minals can be found on the next page.
Final assembly
Reattach the casing parts. To assemble, carry out the
disassembly operation steps in reverse order.
NOTE
i
Tighten the screws with the required torque (max.
1.2 Nm).
B
A
C
Bekijk gratis de handleiding van Dimplex VFE 70, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dimplex |
| Model | VFE 70 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 7629 MB |
