Handleiding
Je bekijkt pagina 18 van 24
Error Codes
ERROR CODES
E0 - Indicates the room temperature sensor has failed.
E1 - Indicates the condenser temperature sensor has failed
E2 - Indicates the internal water container is full. Refer to the Water Drainage section
below.
E3 - Evaporator temperature sensor has failed
TROUBLESHOOTING
Issue Possible Causes Suggested Remedies
1. Unit does not start when
pressing on/off button
Water full indicator blinks and
water tray is full
Empty the water out of the water
tray
Room temperature is lower than
the set temperature
Reset the temperature
2. The room isn't cool enough
Thermostat range
Cooling Capacity
Dehumidication Capacity
Noise Level
The doors and windows are not
closed
Make sure all the windows and
doors are closed
There are heat sources inside the
room
Remove the heat sources if possible
Exhaust air hose is not connected
or blocked
Connect or clean the exhaust hose
Temperature setting is too high Reset the temperature
Air inlet is blocked
Clean the air inlet
3. The unit is noisy
The ground is not level
Place the unit on a at, level ground
if possible
The sound comes from the ow-
ing of the refrigerant inside the
air conditioner
This sound is normal during opera-
tion
18
Bekijk gratis de handleiding van Dimplex DCP26JS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dimplex |
| Model | DCP26JS |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2320 MB |
