Digi-Pas DWL5800XY handleiding
Handleiding
Je bekijkt pagina 19 van 73
Digi-Pas
®
© 2023 Digipas Technologies Inc. All Rights Reserved.
www.digipas.com
Page 13
DWL-5x000XY DATA SHEET
3.2.2. Conguration Setup Procedure (RS485)
1. Prepare the custom cable. The constructed custom cable and the pinout of the
DB9 (Female) connector is shown in Figure 19.
Pin No. Description
1 GND
2 N.C (No Connection)
3
GND (without Control Box) or Signal 1 (For
Control Box only)
4
GND (without Control Box) or Signal 2 (For
Control Box only)
5 Power Input (Regulated 9V)
6 RS485 - A (Non-inverting Receiver Input/Tx+)
7 RS485 - B (Inverting Receiver Input/Tx-)
8 RS485 - Z (Inverting Driver Output)/Rx-)
9 RS485 - Y (Noninverting Driver Output / Rx+)
DB-9 (Female) Connector
Figure 19. Constructed custom cable and pinout of the DB9 (Female) connector
2. Connect the custom cable with sensor cord and ES-U-3001-M converter as in fol-
lowing connection pinout illustrated in Figure 20.
Figure 20. Connection custom cable and ES-U-3001-M converter
3. The conguration is then completed. Users can obtain data through PC Sync
software please refer to “4. Operation”, using Digi-Pas DLL refer to “5.2 DLL for Se-
rial Communication Protocol Direct to Sensor” or direct programming refer to “6.
RS485/232 Serial Communication Protocol for Single DWL5x00XY Tilt Sensor”
Bekijk gratis de handleiding van Digi-Pas DWL5800XY, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Digi-Pas |
| Model | DWL5800XY |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10950 MB |
