Deye SUN-29.9K-SG01HP3-EU-BM3 handleiding

Niet gecategoriseerd

Deye

61 pagina's

PDF beschikbaar

Handleiding

Sensor Clamp

x 3

- 07 -

3.2 Mounting instructions

Installation Precaution

This Hybrid inverter is designed for outdoor use(IP65), Please make sure the installation site

meets below conditions:

Excessive heat buildup, heavy rainfall or water pooling, can impact the performance and

longevity of the inverter. Before connecting all wires, please take oﬀ the metal cover by

removing screws as shown below:

· Not in direct sunlight, rain exposure, snow laying up during installation and operation.

· Not in areas where highly ﬂammable materials are stored.

· Not in potential explosive areas.

· Not directly expose to the cold air to avoid condensation inside the inverter casing .

· Not near the television Antenna or antenna cable.

· Not higher than altitude of about 2000 meters above sea level.

· Not in environment of precipitation or humidity(>95%)

DC+/DC- Plug connectors

including metal terminal

Battery Plug connectors

accessories x4

T-type wrench

Stainless steel mounting

screws M4*12 x9

Solar Photovoltaic

Connector Special

Spanner x1

7,8,*9

Magnetic ring for AC

wires x3

(50×65×25 mm)

4,5,6

Magnetic ring for CT x3

(31×29×19 mm)

Magnetic ring for

commuication cable of

BMS and Meterx3

(23×33×15 mm)

1,2,3

Matching Resistor x1

*9:If this magnetic ring is not

included in the accessory

package, it should have already

been pre installed at the inlet of

the grid cable.

*9 place it on top of the

EPE material cover

1,2,3 : 23×33×15 mm

4,5,6 : 31×29×19mm

7,8,9 :50×65×25 mm

1 2

7 8

Packing box of magnetic ring

Bekijk gratis de handleiding van Deye SUN-29.9K-SG01HP3-EU-BM3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.