DeWalt DXV16P handleiding
Handleiding
Je bekijkt pagina 7 van 12
WARNING:
To reduce the risk of fire or explosion, do not
operate this vac in areas with flammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited
to: coal, magnesium, aluminum, and grain
or gun powder. Do not vacuum explosive
dust, flammable or combustible liquids or hot
ashes. Do not use this vac as a sprayer for any
flammable or combustible liquid. To reduce the
risk of health hazards from vapors or dusts,
do not vacuum toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
After the power cord has been plugged into the
power outlet, turn the unit “ON” by pushing the
switch toward the “I” position. To turn “OFF”,
push switch to the “O” position.
ON OFF
5
1. The filter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the filter is completely
covering the filter cage. Make sure there are
no gaps between the filter and the lid. It is
very important to assemble the filter to the
cage without any possible leaks or tears.
DRY PICK-UP
ENGLISH
2. When using the vac to pick up fine dust,
it will be necessary to empty the dust tank and
clean or replace the filter at more frequent
intervals to maintain peak vac performance.
1. With the power head in an upside down position,
slide the cartridge filter down over the lid cage,
push the filter seals against the power head.
2. Turn the knob on filter retainer clockwise to
tighten, the filter into place.
3. To remove the filter for cleaning, turn the filter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the filter cap,
then slide the cartridge filter off the lid cage.
then grasp the step of knob tightly with fingers
to pull the cartridge filter out off the cage.
4. To clean the cartridge filter, shake or brush off
excess dirt or rinse (from the inside of the filter)
with water, dry completely (approximately 24
hours) and re-install.
The cartridge filter can be used for wet or dry
pick-up, installation is the same for both.
INSTALLING THE CARTRIDGE FILTER
NOTICE:
A dry filter is necessary to pick up dry material. If
use the vac to pick up dust when the filter is
wet, the filter will clog quickly and be very difficult
to clean. If the filter gets wet, replace it before
continuing to do dry pickups.
NOTICE:
If the filter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
Lock
Bekijk gratis de handleiding van DeWalt DXV16P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DXV16P |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 1610 MB |
