DeWalt DXPGH2SB21 handleiding
Handleiding
Je bekijkt pagina 5 van 50
DXPGH2SB21 / DXPGB2WD21
5
USER INSTRUCTIONS / CAUTIONS / WARNINGS
USER INSTRUCTIONS
Please read these instructions and then store them in a safe place for future reference.
The respirator must be fitted and used in accordance with these instructions to obtain the
approved level of performance.
Images in this manual may show the standard face shield model but the instructions will be
applicable to both DXPGH2SB21 and DXPGB2WD21 models (unless otherwise stated).
CAUTIONS
• For adequate protection this respirator must fit or be adjusted to the size of the user’s
head.
• The respirator is made to absorb the energy of a blow by partial destruction or damage to
the shell and the harness, and even though such damage may not be readily apparent, any
respirator subjected to severe impact should be replaced.
• The attention of users is also drawn to the danger of modifying or removing any of the
original component parts of the respirator, other than as recommended by the respirator
manufacturer.
• Respirators should not be adapted for the purpose of fitting attachments in any way not
recommended by the respirator manufacturer.
• Do not apply paint, solvents, adhesives or self-adhesive labels, except in accordance with
instructions from the respirator manufacturer.
WARNINGS
• REPAIR IS BY REPLACEMENT OF DEFECTIVE PARTS ONLY.
• ONLY APPROVED D
EWALT DXPGH2SB21 AND/OR DXPGB2WD21 PARTS SHOULD BE USED
(MODEL DEPENDANT).
• ALTERATIONS AND AFTER-MARKET MODIFICATIONS TO HEADWEAR PRODUCTS MIGHT
COMPROMISE THE PROTECTIVE FEATURES OF THE HEADWEAR.
• RESPIRATORS MUST BE STORED IN ACCORDANCE WITH THESE INSTRUCTIONS.
(INCLUDING DURING BREAK TIMES etc.) RESPIRATORS MUST BE REGULARLY CLEANED IN
ACCORDANCE WITH THESE INSTRUCTIONS.
• RESPIRATORS MUST BE DECONTAMINATED IN ACCORDANCE WITH THESE INSTRUCTIONS.
• THE HEADBAND, CONCUSSION STRAPS, FIXINGS AND MOUNTING POINTS FORM PART OF
THE STRUCTURE OF THE RESPIRATOR. ENSURE THAT THE NEW ASSEMBLY IS FITTED
CORRECTLY, OR THE INTEGRITY OF THE RESPIRATOR MAY BE COMPROMISED.
• PRIOR TO USE A FLOW CHECK MUST BE PERFORMED.
• DO NOT HOLD OR SUSPEND THE RESPIRATOR BY THE HEADBAND OR FACE SEAL.
• DO NOT WEAR THE RESPIRATOR IF THE AIR FLOW IS SWITCHED OFF.
• AT VERY HIGH WORK RATES THE PRESSURE IN THE DEVICE MAY BECOME NEGATIVE AT
PEAK INHALATION FLOW.
Bekijk gratis de handleiding van DeWalt DXPGH2SB21, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DXPGH2SB21 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6733 MB |
