DeWalt DCMPS640 handleiding
Handleiding
Je bekijkt pagina 40 van 192
38
ENGLISH
used. Operating at height without proper training could increase
the risk of personal injury or death. Make sure you are secured. Keep
scabbard installed when not in use. Do not overreach. Extend pole
only as far as necessary. Do not operate near power lines.
GENERAL SAFETY RULES
DANGER: Shock Hazard. Serious injury or death from
electrocution if power lines are contacted. Never use near any
electrical source, wires, or powerlines.
WARNING: For safe operation read and understand the
instruction manual.Wear face shield (and/or safety glasses) and
hard hat to protect against falling debris.Always have a clear work
area, retreat path, and be aware of limb/branch location to avoid
falling limbs and debris.Keep bystanders
15m (50')
away when
operating saw.To reduce the risk of electric shock do not use on wet
surfaces.Do not expose to rain.Storeindoors.
WARNING: This product (not including the battery pack
or charger) provides some level of protection from dust (limited
ingress) and liquids (light splashing) during normal and reasonably
foreseeable use. The battery pack and charger do not have an
IP rating on their own. NEVER submerge the product, battery or
charger in liquid.
• To protect yourself from falling branches do not stand directly
under the branch or limb being cut. This unit should not be held at
an angle over 60° from groundlevel.
• Keep the handles dry, clean, and free ofoil.
• Before you start the unit, make sure the chain is not contacting
anyobject.
• Make sure the cutting chain has stopped before setting the
unitdown.
Service
• Tool service must be performed only by qualified repair
personnel. Service or maintenance performed by unqualified
personnel could result in a risk of injury. Refer to the Maintenance
section of thismanual.
• When servicing a tool, use only identical replacement parts.
Follow instructions in the Maintenance section of this manual. Use
of unauthorized parts or failure to follow maintenance instructions
may create a risk of electric shock orinjury.
Guard Against Kickback
WARNING: KICKBACK may occur when the nose or tip of
the guide bar touches an object, or when the wood closes in and
pinches the saw chain in the cut. Tip contact in some cases may
cause a lightning fast reverse reaction, kicking the guide bar up
and back towards the operator. Pinching the saw chain along the
top of the guide bar may push the guide bar rapidly back towards
the operator. Either of these reactions may cause you to lose
control of the saw which could result in serious injury touser.
The following precautions should be followed to
minimize kickback:
• Hold the saw firmly with both hands when the unit is running.
Use a firm grip with thumbs and fingers encircling the main pole
handle and the insulated hand grip. DO NOT use the pole as a
graspingsurface.
• Do notoverreach.
• Keep proper footing and balance at alltimes.
• Don’t let the nose of the guide bar contact a log, branch, ground
or otherobstruction.
• Do not extend pole saw handle above shoulderheight.
While Operating Pole Saw
DANGER: To reduce the risk of electric shock do no use
on wet surfaces. Do not expose to rain. Storeindoors.
DANGER: Avoid Unintentional Starting – with battery
installed, don’t carry appliance with with finger on switch. Be sure
switch is off when installingbattery.
• Hold the tool using only the designated gripping surfaces: the
main pole handle and the pole.
• Stay alert. Use common sense while operating theunit.
• Keep work area clean. Cluttered areas inviteinjuries.
• Always remove battery from pole saw when finished cutting or
when leftunattended.
• Keep children, animals and bystanders at least 15m (50') away
from pole saw. Only pole saw user should be in workarea.
• Do not use the pole saw to cut downtrees.
• Do not grasp the exposed saw chain when picking up or holding
the polesaw.
• Keep finger off trigger until ready to makecut.
• Before starting pole saw, make sure chain is not touchinganything.
• Keep all parts of body away from chain when pole saw
isrunning.
• Do not force pole saw while cutting. Apply light pressure. It will do
the job better and safer at the rate for which it wasintended.
• Carry pole saw from one place to another:
ʵ with battery removed,
ʵ fingers off/away from trigger,
ʵ by holding pole at balance point, and
ʵ with guide bar and chain to rear and with scabbardattached.
• Do not cut small brush and saplings with the pole saw. Slender
matter may catch in the chain and be whipped toward you. This
could also pull you offbalance.
• Do not operate in poorlighting.
• Keep firm footing and balance. Do not overreach. Overreaching can
result in loss of balance.
• Keep all parts of your body away from any movingpart.
• Do not, under any circumstance, use any attachment or
accessory on this product, which was not provided with the
product, or identified as appropriate for use with this product in
this instructionmanual.
• Inspect pole saw before each use and after dropping or other
impacts. Ensure there are no significant defects ordamage.
Do Not Operate Pole Saw:
ʵ while under the influence of alcohol, medication, ordrugs.
ʵ in rain or in damp or wetareas.
ʵ where highly flammable liquids or gases arepresent.
ʵ if pole saw is damaged, adjusted incorrectly, or not fully and
securelyassembled.
ʵ if trigger does not turn pole saw on and off. Chain must stop
moving when you release trigger. Have faulty switch replaced by
authorized service center. See Accessories underMaintenance.
ʵ while in ahurry.
ʵ while in a tree or on aladder.
ʵ while onplatforms.
ʵ during high wind or stormingweather.
ʵ Do not use in buckets or on arial booms unless specifically
trained to do so and in accordance with training materials. Follow
all instructions and safety warnings of bucket or arial boom being
Bekijk gratis de handleiding van DeWalt DCMPS640, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DCMPS640 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 34401 MB |
