DeWalt DCE050 handleiding
Handleiding
Je bekijkt pagina 9 van 24
7
English
TROUBLESHOOTING
WARNING: Risk of unsafe operation. Remove the battery before servicing and discharge any residual fluid.
PROBlEM CAUsE CORRECTiOn
Motor does not start.
Battery pack not installed properly. Check battery pack installation.
Battery pack not charged. Check battery pack charging requirements.
On/off switch is in the OFF position. Press the on/off switch to the ON position.
Pump does not reach high pressure. Impeller cover is not sealed/tight. Ensure impeller glass is seated correctly.
Ensure impeller gasket is seated correctly.
Hand-tighten the four impeller cover screws.
Water inlet line is clogged. Check inlet line for blockages or excessive bends. Clear blockages and undo any kinks.
Impeller is worn out. Replace with new impeller. See Impeller section.
Pump is sucking air. Check that hoses and fittings are air tight. Check inlet and outlet lines for kinks, blockages or excessive bends. Clear
blockages and undo any kinks.
Water supply restricted. Check water hose for kinks, leaks and blockage.
Pump turns off. Not enough inlet water supply. Adjust the intake line stays fully covered with liquid. Check hose for leaks and kinks.
Pump is sucking air. Check that hoses and fittings are air tight. Turn the pump OFF and then back on.
Water inlet clogged. To unclog, rinse off with clean water.
Impeller is locked in place. Blow out or remove debris.
Battery pack not charged. Check battery pack charging requirements.
Hose connection leaks. Loose fittings. Tighten fittings.
Missing/worn rubber washer. Replace washer in hose adapter.
Pump does not self prime. Loose fittings. Tighten fittings.
Line intake is not fully submerged. Adjust the line intake so that it stays fully covered with liquid.
Allow more time for pump to prime.
Pump is excessively noisy. Pump is sucking air. Check that hoses and fittings are air tight.
Water leaks from pump. Loose fittings. Check that all fittings are tight.
Water seals are damaged or worn. Contact DeWALT customer service representative at 1-800-4-DeWALT (1‑800‑433‑9258).
Motor buzzes but fails to run. Impeller is locked in place. Inspect/replace with a new impeller. See Impeller section.
Pump was not used for long periods. Inspect/replace impeller or contact DeWALT customer service representative at 1-800-4-DeWALT (1‑800‑433‑9258).
Bekijk gratis de handleiding van DeWalt DCE050, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DCE050 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4027 MB |
