Handleiding
Je bekijkt pagina 49 van 60
4949
ELECTRONIC PROGRAMMER DISPLAY CLEANING (models PRO66MXLPZ,
PRO66MALPZ only)
Clean the programmer display using a soft cloth, warm water and neutral soap, or a soft
cloth with a liquid detergent (non-abrasive).
When cleaning, be careful to move the cloth in one direction only.
Then wipe the display with a damp cloth and dry it with a soft cloth.
IMPORTANT: DO NOT use chlorine-based or acid-based cleaning products, abrasive
products or non-neutral detergents as they may cause irreparable damage to the
surface. DO NOT spray cleaning liquids directly on the programmer display.
BURNERS
■ They can be removed. These parts must be cleaned using a sponge and soapy water
or other suitable non-abrasive products. Dry with a soft cloth.
Warning! Not dishwasher safe.
■ If left on the surface for a length of time, acidic substances such as lemon juice, tomato
sauces and passata, vinegar and other similar products will damage the surface and
dull its shine.
■ After cleaning, the burners and their ame spreaders must be well dried and correctly
replaced. It is very important to check that the burner ame spreader and the cap have
been correctly positioned. Failure to do so can cause serious problems.
■ Check that the electrode “S” (gs. 30, 32) next to each burner is always clean to
ensure trouble-free sparking.
■ Check that the probe “T” (gs. 30, 32) next to each burner is always clean to ensure
correct operation of the safety valves.
Note: Both the probe and ignition electrode must be very carefully cleaned.
To avoid damage to the electric ignition do not use it when the burners are not in
place.
Note: Continuous use may cause a change in the glaze around the burners and
grids, corresponding to the areas exposed to the heat. This is a natural phenomenon
and does not prevent the parts from working properly.
AUXILIARY AND SEMI-RAPID BURNERS
It is essential to check that the burner ame distributor “F” and the cap “C” have been
correctly positioned (see gs. 30, 31) - failure to do so can cause serious problems.
DOUBLE-RING COMPACT BURNER
The double-ring compact burner must be correctly positioned (gs. 32, 33, 34); the burner
rib must be located in position as shown by the arrows.
The burner correctly positioned must not rotate (g. 33).
Then position the cap “A” and the ring “B” (gs. 33, 34).
Bekijk gratis de handleiding van Delonghi PRO 66 MXL PZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Delonghi |
| Model | PRO 66 MXL PZ |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5778 MB |
