Handleiding
Je bekijkt pagina 15 van 56
1515
CONNECTION OF THE POWER SUPPLY CABLE
Important! The appliance must be connected to the electricity supply only by an
authorised person.
To connect the feeder cable to the cooker it is necessary to carry out the following operations:
■ Unhook the terminal board cover “A” by inserting a screwdriver into the two hooks “B”
(g.11). Open completely the terminal block cover “A”.
■ Unscrew the screw “C”, then unhook the cable clamp “D” by inserting a screwdriver
into the hook “E”. Remove completely the cable clamp “D” (g. 11).
■ Connect the phase, neutral and earth wires to terminal board “F” according to the
diagrams in g. 12; the U bolts “G” (g. 11) shall be used as indicated in the diagrams
in g. 12 (they are supplied already tted to the terminals or inside the terminal board,
behind the cover).
■ Strain the feeder cable and block it with cable clamp “D” (by hooking hook “E” and
screwing screw “C”).
■ Close the cover “A” of the terminal board “F” (check the two hooks “B” are correctly
hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws xing
the cover plate behind the terminal block.
If the supply cord (not supplied with the appliance) is damaged, it must be replaced
by the manufacturer or its service agent or a similarly qualied person in order to
avoid a hazard.
VOLTAGE AND POWER
CONSUMPTION
220-240/380-415 V 2N, 50-60 Hz
8500 W - 36.96 A (@230V)
FEEDER CABLE SECTION (USE
A TYPE OF CABLE ACCORDING
TO THE APPLICABLE LOCAL
REGULATIONS)
220-240 V ac 3 x 6 mm
2
(*)
380-415 V 2N ac 4 x 4 mm
2
(*)
(*) Connection with wall box connection.
Figure 10
Bekijk gratis de handleiding van Delonghi DMX 64 INL TC2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Delonghi |
| Model | DMX 64 INL TC2 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4822 MB |
