Handleiding
Je bekijkt pagina 16 van 56
1616
CONNECTION OF THE POWER SUPPLY CABLE
Important! The appliance must be connected to the electricity supply only by an
authorised person.
To connect the feeder cable to the cooker it is necessary to carry out the following operations:
■ Unhook the terminal board cover by inserting a screwdriver into the two hooks “A” (g.
11).
■ Unscrew the screw “D” and open completely the cable clamp “E” (g. 12).
■ Position the U bolts “F” onto terminal board “G” (g. 12) according to the diagrams in
g. 13.
■ Connect the phase, neutral and earth wires to terminal board “G” according to the
diagrams in g. 13.
■ Strain the feeder cable and block it with cable clamp “E” (by screwing screw “D”).
■ Close the terminal block cover (check the two hooks “A” are correctly hooked, g 11).
NOTE: The earth conductor must be left about 3 cm longer than the others.
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws xing
the cover plate behind the terminal block.
If the supply cord (not supplied with the appliance) is damaged, it must be replaced
by the manufacturer or its service agent or a similarly qualied person in order to
avoid a hazard.
VOLTAGE AND POWER
CONSUMPTION
■ 220-240/380-415 V 3N, 50-60 Hz
9200 W - 40 A (@230V)
FEEDER CABLE SECTION (USE
A TYPE OF CABLE ACCORDING
TO THE APPLICABLE LOCAL
REGULATIONS)
220-240 V ac 3 x 6 mm
2
(*)
380-415 V 3N ac 5 x 1,5 mm
2
(*)
380-415 V 2N ac 4 x 4 mm
2
(*)
(*) Connection with wall box connection.
A
Figure 11
Bekijk gratis de handleiding van Delonghi DEF1407INDMB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Delonghi |
| Model | DEF1407INDMB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4689 MB |
