Dell Pro 14 Essential PV14255 Handleiding (140 Pagina's)

Handleiding

Figure 4. Pressing the power button to drain flea power

Steps

1. Loosen the two captive screws and then remove the six screws (M2x4) that secure the base cover to the palm-rest and

keyboard assembly.

2. Using a plastic scribe, pry open the base cover starting from the recesses, which are located in the U-shaped indents at the

top edge of the base cover, near the hinges.

CAUTION:

Do not slide the scribe along the edges of the base cover as it may damage the latches inside the

base cover. Instead, insert the scribe at regular intervals and pry open the base cover.

3. Pry open the top of the base cover followed by the left, right, and bottom to release the base cover.

4. Lift the base cover off the palm-rest and keyboard assembly.

5. Disconnect the battery cable from the connector (BATT1) on the system board.

6. Press and hold the power button for 15 to 20 seconds to ground the computer and drain the flea power.

Installing the base cover (for computers shipped with a plastic

chassis)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the base cover and provide a visual representation of the installation procedure.

16

Removing and installing Customer Replaceable Units (CRUs)

Bekijk gratis de handleiding van Dell Pro 14 Essential PV14255, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.