Handleiding
Je bekijkt pagina 51 van 99
Figure 27. Display assembly
Steps
1. Peel the tape that secures the display-assembly cable to the latch on the system board.
2. Lift the latch and disconnect the infrared camera cable from the connector (CIR) on the system board.
3. Lift the latch and disconnect the display-assembly cable from the connector (LCD) on the system board.
4. Remove the two screws (M2.5x5) that secure the left display-assembly hinge to the system board.
5. Pry open the left display-assembly hinge to a 90-degree angle.
6. Remove the three screws (M2.5x5) that secure the right display-assembly hinge to the system board.
7. Pry open the right display-assembly hinge to a 90-degree angle.
8. Lift the palm-rest and keyboard assembly at an angle off the display assembly.
Installing the display assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
51
Bekijk gratis de handleiding van Dell 14 Plus DB14250, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dell |
| Model | 14 Plus DB14250 |
| Categorie | Laptop |
| Taal | Nederlands |
| Grootte | 38915 MB |
