Delfield 186114PTBMP handleiding
Handleiding
Je bekijkt pagina 23 van 24
Part Number: 9291455 08/17 23
Section 4 Maintenance
Drawer Assembly Cleaning
The drawer assembly is designed to be cleaned easily. Both
drawer and tracks are removable without tools. The drawer
tracks are dishwasher safe or can be cleaned in a sink with
detergents and a soft bristle brush. Drawers and tracks
should be cleaned on a weekly basis.
Remove Drawers
Pull the drawer box out until it stops. Lift up on the drawer
front and pull the drawer box completely out. Using a soft
bristle brush, clean the track on the bottom of the drawer
box. When finished, it should be wiped clean of all food and
debris.
Tracks
The drawer box assembly must be removed. Pull the drawer
tracks out until they hit a stop. Locate blue safety clips
towards the back of each drawer track. Blue safety clips have
a tab on the top. Push the tab back until it clicks. Lift up and
pull the drawer tracks all the way out of the drawer cage.
The drawer tracks are
dishwasher safe or can
be cleaned in a sink with
detergents and a soft
bristle brush. Drawers
and tracks should be
cleaned on a weekly
basis. Using a soft bristle brush, wash the track making sure
each roller is thoroughly cleaned. The drawer cage should
be cleaned with a soft bristle brush, removing any food and
debris gathered on the bottom ledge. Once it’s cleaned
thoroughly with a soft bristle brush, wipe remaining debris
clean with a soft towel.
Reassembly
Push the drawer tracks into the drawer cage. The blue safety
clip must remain pushed towards the back. Lift up and slide
the drawer track all the way into the drawer cage. The blue
safety clip will lock in place automatically. Once all tracks are
replaced, insert the drawer box. Rest the drawer box bottom
track on the front track roller. Then push the drawer back
in place SLOWLY. When the drawer box is about half way in
you will hit a STOP. You must lift the front of the drawer up
approximately ½” (1.3cm) to continue inward. Clean tracks as
often as possible. The cleaner the tracks are the better they
will operate.
Doors
Over time and with heavy-use doors, the hinges may become
loose. If this happens, tighten the screws that mount the
hinge brackets to the frame of the unit. Loose or sagging
doors can cause the hinges to pull out of the frame, which
may damage both the doors and the hinges. In some cases
this may require qualified service agents or maintenance
personnel to perform repairs.
Cleaning The Condenser Coil
In order to maintain proper refrigeration performance, the
condenser fins must be cleaned of dust, dirt and grease
regularly. It is recommended that this be done monthly. If
conditions are such that the condenser is totally blocked
in a month, the frequency of cleaning should be increased.
Clean the condenser with a vacuum cleaner or stiff brush. If
extremely dirty, a commercially available condenser cleaner
may be required.
Failure to maintain a clean condenser coil can initially cause
high temperatures and excessive run times. Continuous
operation with a dirty or clogged condenser coil can result in
compressor failure. Neglecting the condenser coil cleaning
procedures will void any warranties associated with the
compressor and cost to replace the compressor.
tab on top of blue
safety clip
Bekijk gratis de handleiding van Delfield 186114PTBMP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Delfield |
| Model | 186114PTBMP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4020 MB |
