Handleiding
Je bekijkt pagina 14 van 24
Page 14
DANGER Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected to the
mains supply only by an authorized
qualified person and the appliance is
only guaranteed after correct
installation.
DANGER Risk of electric shock, short
circuit or fire by damage of the mains
lead!
The mains lead must not be clamped,
bent or trapped or come into contact
with hot parts of the appliance. If the
mains lead is damaged, it must be
replaced by a qualified electrician.
x Connection must comply with national regulations.
x The mains supply data must correspond to the data
specified on the type label of the appliance. Type
label is at the rear housing of the appliance.
x Power cable of your product must comply with the
values in "Technical specifications" table.
DANGER Risk of electric shock!
Before starting any work on the
electrical installation, please disconnect
the appliance from the mains supply.
The power cable plug must be within
easy reach after installation (do not
route it above the hob).
Gas connection
DANGER Risk of explosion or
poisoning by unprofessional installation.
The appliance may be connected to the
gas distribution system only by a
registered LPG installer.
DANGER Risk of explosion!
Before starting any work on the gas
installation, please shut off the gas
supply.
x Gas adjustment conditions and values are stated
on labels (or on type label).
Your appliance is adjusted for LPG gas.
Connecting the gas hose
x Have your appliance connected so that it will be
close to the gas connection. Ensure that there is
no gas leakage.
x Gas bottles should be located outdoors in a
suitable ventilated lock-up.
x The connecting hose to be used must not be
longer than 125 cm in length.
x Install the clamp to the hose. Soak one end of the
hose (15 mm inner diameter) into hot water for one
minute to soften it. Then, slip the softened end of
the hose completely onto the sharp hose tip of
your appliance.
x Secure the hose by tightening the hose clamp
x Repeat the same procedure for the other end of
the hose by securing the other end of the hose to
the regulator on the gas bottle to complete the gas
cylinder connection.
x Always check for gas leaks after installation and
whenever a new or refilled gas bottle is used for
the first time.
Electrical connection
Connect the appliance to a grounded outlet/line
protected by a fuse of suitable capacity as stated in
the "Technical specifications" table. Have the
grounding installation made by a qualified electrician
while using the product with or without a transformer.
The manufacturer shall not be held responsible for
damages arising from procedures carried out by
unauthorized persons.
Plug the power cable into the socket.
Bekijk gratis de handleiding van Defy DHG614, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Defy |
| Model | DHG614 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2758 MB |
