Handleiding
Je bekijkt pagina 12 van 22
Page 12
DANGER Risk of electric
shock, short circuit or fire by
unprofessional installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the appliance is only guaranteed
after correct installation.
DANGER Risk of electric
shock, short circuit or fire by
damage of the mains lead!
The mains lead must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance. If the mains lead
is damaged, it must be replaced
by a qualified electrician.
• Connection must comply with national
regulations.
• The mains supply data must correspond to
the data specified on the type label of the
appliance. Type label is at the rear
housing of the appliance.
• Power cable of your product must comply
with the values in "Technical
specifications" table.
DANGER Risk of electric
shock! Before starting any work
on the electrical installation,
please disconnect the appliance
from the mains supply.
The power cable plug must be
within easy reach after installation
(do not route it above the hob).
Electrical connection
Connect the appliance to a grounded outlet/
line protected by a fuse of suitable capacity
as stated in the "Technical specifications"
table. Have the grounding installation made
by a qualified electrician while using the
product with or without a transformer.
The manufacturer shall not be held
responsible for damages arising from
procedures carried out by unauthorized
persons.
In case of power failure manually ignite the
burner using an ignitor gun.
Gas connection
DANGER Risk of explosion or
poisoning by unprofessional
installation. The appliance may
be connected to the gas
distribution system only by a
registered LPG installer.
DANGER Risk of explosion!
Before starting any work on the
gas installation, please shut off
the gas supply.
• Gas adjustment conditions and values are
stated on labels (or on type label).
Your appliance is adjusted for LP
gas.
Connecting the gas hose
• Have your appliance connected so that it
will be close to the gas connection.
Ensure that there is no gas leakage.
• Gas bottles should be located outdoors in
a suitable ventilated lock-up.
• The connecting hose to be used must not
be longer than 200 cm in length.
• Install the clamp to the hose. Soak one
end of the hose (15 mm inner diameter)
into hot water for one minute to soften it.
Then, slip the softened end of the hose
completely onto the sharp hose tip of your
appliance.
• Secure the hose by tightening the hose
clamp
• Repeat the same procedure for the other
end of the hose by securing the other end
of the hose to the regulator on the gas
bottle to complete the gas cylinder
connection.
• Always check for gas leaks after
installation and whenever a new or refilled
gas bottle is used for the first time.
Caution: Never use a naked flame
to check for gas leaks
DANGER Risk of explosion and
suffocation! The maximum bottle
size allowed in the house is 19 Kg.
(Flat—9Kg)
• Plug the power cable into the socket.
Bekijk gratis de handleiding van Defy DHG606, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Defy |
| Model | DHG606 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3390 MB |
