Handleiding
Je bekijkt pagina 11 van 37
11
Periodically check the condition of the power cord. Do not pull on the power
cord.
8. Switching on the device
Before starting the device, it is essential to perform the
steps described in the "Preparation for operation"
section.
The heater is started by turning the heating selector knob from the "OFF"
position and the thermostat from "MIN" - see Fig. B - to the next values (see
section 9. "Using the device").
9. Using the device
Do not cover or block any of the heat outlet grilles or
air inlets while the device is in operation!
How to use the heater:
1. Connect the device to the power supply (note: before connecting the cable,
check that the heating selector knob is set to "O/OFF" and the thermostat to
"MIN" - see fig. B)
2. Set the thermostat knob (Fig. B) to the maximum position (clockwise until it
stops).
3. Set the heating selection knob (Fig. B) to one of the heating positions. The
fan and heater elements will switch on.
4. When the air in the room reaches the set temperature, the heaters will switch
off automatically. If the temperature in the room drops, the heaters will switch on
again automatically. The heaters will switch on and off automatically,
maintaining the temperature in the room at the set level.
5. Before switching off the device, turn off the heaters, set the operating mode
knob to the fan position, and turn the thermostat knob clockwise until it stops.
Wait about 5-10 minutes for the heater to cool down completely, then set the
operating mode knob to "0" and switch off the device.
6. After finishing work, disconnect the device from the power supply. If the device
overheats, the temperature sensor will activate and switch off the heaters in the
heater. The fan will continue to operate until the temperature in the room drops,
at which point the temperature sensor will automatically switch on the heater
heaters.
10. Routine maintenance
All maintenance activities must be carried out with the
device disconnected from the power supply.
The device should be cleaned and vacuumed regularly. Cleaning should be
carried out by vacuuming dirt from the housing and the interior of the device
using a vacuum cleaner nozzle. Use a soft, dry cloth to clean the housing. Do
not use aggressive detergents, chemical cleaning agents, solvents or other
agents that could damage the surface of the device.
Storage and transport
When the device is not in use, store it disconnected from the power supply, out
of the reach of children, in a dry and well-ventilated place. The device and other
items listed in the package should be transported in their original packaging, if
possible, in a manner that does not expose them to harmful environmental
conditions such as moisture, precipitation, high temperatures (above 50°C),
pressure that may result in mechanical damage, and other conditions that may
adversely affect the packaging or its contents.
11. Spare parts and accessories
To purchase spare parts and accessories, please contact Dedra Exim. Contact
details can be found on page 1 of the manual.
When ordering spare parts, please provide the batch number on the nameplate
and the part number from the assembly drawing.
During the warranty period, repairs are carried out in accordance with the terms
and conditions specified in the warranty card. Please return the product to be
repaired to the place of purchase (the seller is obliged to accept the product),
send it to the Dedra Exim central service centre or send it to the service centre
closest to your place of residence (list of service centres at www.dedra.pl).
Please enclose the completed warranty card. After the warranty period, repairs
are carried out by the central service centre. The damaged product should be
sent to the service centre (shipping costs are covered by the user).
12. Independent troubleshooting
Before attempting to repair the product yourself,
disconnect it from the power supply.
Problem
Cause
Solution
The motor is running, but
the device is not heating
Defective thermostat
Send the device for repair
Damaged heating
element
Send the device for repair
The motor is not running,
but the heaters are
heating up
Damaged motor
Send the device for repair
Fan blocked
Unblock/clean the fan
Damaged switch
Send the device for repair
The entire device is not
working
Break in the electrical
circuit
Check the power
connection
Damaged switch
Send the device for repair
Reduced air flow
Contaminated air duct
Clear the air duct
Damaged motor
Send the device for repair
13. Device assembly
1. Electric heater – 1 pc.
14. Information for users about the disposal of
electrical and electronic equipment (applies to
households)
The symbol shown on the products or accompanying documentation
informs that faulty electrical or electronic equipment must not be
disposed of with household waste. The correct course of action when
disposal, reuse or recovery of components is to take the device to a
specialized collection point, where it will be accepted free of charge. Information
on the location of collection sites for waste equipment is provided by local
authorities, e.g. on their websites.
Proper disposal of the device allows you to conserve valuable resources and
avoid negative health and environmental impacts resulting from the possibility
of hazardous: substances, mixtures and components in the equipment.
Improper disposal of waste is subject to penalties under relevant local
regulations.
Users in European Union countries: If you need to dispose of electrical or
electronic equipment, please contact your nearest retailer or supplier, who will
provide more information.
Disposal of waste in countries outside the European Union: This symbol applies
only to countries within the European Union. If you need to dispose of this
product, please contact your local authorities or your dealer for proper disposal.
Warranty card
at
Electric heater
Part No.: DED9930C2 / DED9931C2Lot No.: ..........................
(hereinafter referred to as the Product)
Product Purchase Date: .............
Dealer stamp
Date and signature of vendor: .................................
User Statement:
I acknowledge that I have been informed of the warranty terms and conditions
and the consequences of not following the guidelines in the User's Manual and
Warranty Card. The terms of this warranty are known to me, which I confirm with
my signature:
........................ ...............................
Date and place Signature of the User
I. Product Liability:
1. Guarantor - Dedra Exim Sp. z o.o. with its registered office in Pruszkow,
address: ul. 3 Maja 8, 05-800 Pruszków, KRS 0000062517, District Court for the
City of Warsaw in Warsaw, XIV Economic Department of the National Court
Register, NIP 527-020-49-33, share capital: PLN 100,980.00.
2. Under the terms of this warranty card, the Guarantor guarantees the Product,
originating from the Guarantor's distribution.
3. Liability under the warranty shall cover only defects arising from causes
inherent in the Product at the time of its release to the User.
4. By virtue of the warranty, the User, obtains the right to repair the Product free
of charge, if the defect became apparent during the warranty period. The method
of repairing the Product (the method of performing the repair) is at the discretion
of the Guarantor. If the Guarantor finds that repair is not possible, the Guarantor
reserves the right to replace the defective element or the entire Product with a
defect-free one, reduce the price of the Product or withdraw from the contract.
5. In relation to the User who is not a consumer within the meaning of the Act of
April 23, 1964. Civil Code, the Guarantor's liability for damages resulting from
this guarantee and/or in connection with its conclusion and execution,
regardless of the legal title, is limited to a maximum of the value of the defective
Product.
II. Warranty Period:
Product Elements
Duration of warranty protection
Electric heater
24 months, starting from the date of purchase of the
Product shown on this warranty card
III. Conditions for taking advantage of the warranty:
The User must present the completed warranty card for the Product and the
User must substantiate the circumstances of the purchase of the Product, e.g.
by presenting a receipt, invoice, etc. In order to carry out the claim efficiently,
the User is advised to submit with the Product for claim all the elements specified
in the "Completion of the device" included in the User's Manual.
2. compliance by the User with the recommendations contained in the User's
Manual and the warranty card.
3. The warranty covers only the territory of the Republic of Poland and the EU.
4. The warranty does not cover Product defects arising in particular from:
a. Failure by the User to comply with the conditions set forth in the User's
Manual, particularly with regard to proper operation, maintenance and cleaning;
b. Use of cleaning or maintenance products by the User that do not comply with
the User's Manual;
c. Inadequate storage and transportation of the Product by the User;
d. Unauthorized changes and/or alterations to the Product by the User, which
were not agreed upon with the Guarantor;
e. User's use of consumables in the Product that do not comply with the User's
Manual.
Bekijk gratis de handleiding van Dedra DED9930C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dedra |
| Model | DED9930C2 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 9805 MB |
