Dedra DED7302 handleiding
Handleiding
Je bekijkt pagina 6 van 35
6
Before connecting the appliance to the power supply, ensure that the
supply voltage corresponds to the value indicated on the rating plate.
The power supply installation should comply with the essential
requirements for electrical installations and meet the safety requirements
for use. The parameters for the minimum cross-section of the supply
cable and the nominal value of the fuse, depending on the power of the
appliance, are given in the table below:
Unit power [W]
Minimum conductor
cross-section [mm2]
Minimum fuse type C
[A]
< 700
0,75
6
The installation should be carried out by a qualified electrician. When
using extension cables, ensure that the conductor cross-section is not
smaller than required (see table). Arrange the electrical cable so that it is
not at risk of being cut during operation. Do not use damaged extension
cords. Periodically check the condition of the power supply cable. Do not
pull on the power cable.
8. Switching on the device
Before starting up the unit, it is essential to carry
out the steps described in the section ‘Preparing
for operation’.
To turn on the charger, connect it to a 230 V mains socket.
9. Operation of the device
When operating the device, all safety rules and
instructions described in the safety conditions
must be strictly observed..
After switching on the charger, place the discharged battery in the
charging socket. Charging is indicated by a red LED. When charging is
complete, the green LED lights up and the charger stops charging to
prevent overcharging of the battery. Remove the charged battery from
the socket. Battery charging time: 2 Ah – approx. 60 minutes, 4 Ah –
approx. 120 minutes
10. Ongoing maintenance
All maintenance must be carried out with the unit
unplugged.
Clean the entire power tool regularly, paying particular attention to
cleaning the ventilation openings of the power tool.
Keep the device out of the reach of children.
Attachment, tool replacement
Once the tool has been clamped, make sure it has been clamped
correctly: lay the power tool horizontally and try to eject the clamped tip.
If it cannot be ejected, it means that it has been clamped correctly.
Maintenance of the appliance
Maintenance includes servicing of the equipment including accessories.
Never carry out maintenance work on equipment
that is connected to a power source.
This can cause serious injury or electric shock.
Maintenance of the unit consists of keeping all its components necessary
for normal operation properly clean. No solvents may be used for
cleaning as this may cause irreparable damage to the casing and other
plastic components.
Before each start-up:
- Check that the engine vents are not obstructed or dirty. If necessary,
expose/clean with a cloth slightly dampened with water.;
11. Spare parts and accessories
For the purchase of spare parts and accessories, please contact the
Dedra Exim service. Contact details can be found on page 1 of the
manual.
When ordering spare parts, please quote the batch number on the
nameplate together with the part number from the assembly drawing.
During the warranty period, repairs are carried out in accordance with the
terms of the warranty card. Return the faulty product for repair at the
place of purchase (the dealer is obliged to accept the faulty product),
send it to the central Dedra Exim service centre or to the service centre
closest to your place of residence (list of service centres at
www.dedra.pl). Kindly enclose the completed warranty card. After the
warranty period has expired, repairs are carried out by the central
service. Send the defective product to the service centre (shipping costs
are paid by the user).
12. Trouble-shooting on your own
Disconnect the unit from the power supply before
attempting to troubleshoot the unit yourself.
Problem
Cause
Solution
The charger
does not charge
the battery.
Power cord not
connected
Connect the power cord.
No mains voltage
Check if there is voltage in
the socket. Check if the fuse
has blown.
Battery not
connected correctly
Check the battery connection
and connect it correctly.
Battery defective
Check the battery. Do not
charge damaged batteries!
Charger defective
Send to service.
13. Contents of the package
1. DED7302 charger – 1 pc,
14 Information for users on the disposal of electrical
and electronic equipment (applicable to households)
The symbol on the products or accompanying documentation
indicates that defective electrical or electronic equipment must not
be disposed of with household waste. If you need to dispose of,
reuse or recover components, take them to a specialist collection
point where they will be accepted free of charge. Information on the
location of collection points for used equipment is provided by local
authorities, e.g. on their websites.
By disposing of the appliance correctly, you will save valuable resources
and avoid negative effects on health and the environment due to the
possible presence of hazardous substances, mixtures and components
in the appliance.
Incorrect waste disposal is subject to penalties according to the relevant
local regulations.
Users in EU countries: If you need to dispose of electrical or electronic
equipment, please contact your nearest point of sale or supplier, who will
be able to provide further information.
Disposal in non-EU countries: This symbol only applies to countries
within the European Union. If you wish to dispose of this product, please
contact your local authorities or dealer for the correct method of disposal.
In accordance with Regulation (EU) 2023/1542 of the European
Parliament and of the Council on batteries and accumulators and waste
batteries and accumulators, defective or used batteries/accumulators
must be collected separately and brought to environmentally compatible
recycling.
Warranty
for
……………….……………………………
(product name)
Catalogue No: ………………. Lot No.: ..........................
(hereinafter called the product)
Product purchase date : .............
Seller’s stamp
Date and seller’s signature: .................................
User’s statement:
I confirm that I have been informed about the warranty conditions and
the consequences of non-compliance with the guidelines in the
Operating Instructions and the warranty. I am aware of the conditions of
this warranty, which I confirm with my handwritten signature:
........................ ...............................
Date and place User’s signature
I. Product liability
1. The Warrantor - Dedra Exim Sp. z o.o. with its registered office in
Pruszków, address: ul. 3 Maja 8, 05-800 Pruszków, KRS
0000062517, District Court for the City of Warsaw in Warsaw, 14th
Economic Division of the National Court Register, TIN 527-020-49-
33, share capital: PLN 100,980.00.
2. The Warrantor provides the warranty for the Product from the
Warrantor 's distribution on the terms set out in this warranty.
3. Liability under the warranty shall only cover defects arising from
causes inherent in the Product at the time of delivery to the User.
4. By virtue of the warranty, the User obtains the right to have the
Product repaired free of charge, provided that the defect became
apparent during the warranty period. The method of repair of the
Product is at the discretion of the Warrantor. If the Warrantor finds
Bekijk gratis de handleiding van Dedra DED7302, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dedra |
| Model | DED7302 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8505 MB |
