Dedra DED6612 handleiding
Handleiding
Je bekijkt pagina 6 van 36
6
Misuse or use not in accordance with the operating instructions will result
in immediate loss of warranty rights.
Permitted operating conditions’
Casual work S2 15 minutes
Use indoors.
5. Technical data
Model type
DED6612
Rated voltage [V]
230
Frequency [Hz]
50
Rated input [W]
1200
Protection class
II
IP number
IPX4
Tank capacity [L]
20
Vacuum [kPa]
16
6. Preparing for use
All operations described in this chapter should be
carried out with the battery disconnected.
Preparing the unit for use:
1. remove the hoover from the packaging, remove the lid, remove the
contents from the hoover tank.
2. ensure that all the components of the appliance have been supplied in
accordance with the parts list (see the appliance manual for a list).
3. place the hoover tank on the base (fig. A, 6), fit the wheels by pressing
the metal pin into the socket hole on the underside.
Depending on the work to be carried out, perform the following steps:
- preparing the hoover for dry work:
1. place a paper bag on the pin protruding in the hoover tank
2. Place a fabric bag on top, making sure that the bag seal fits securely
into the hoover tank.
- preparing the hoover for wet work:
1. place a foam cover over the safety valve basket protruding from the
motor cover. Ensure that the cover fits tightly to the motor housing, smooth
out any unevenness that occurs.
The next steps are common to each type of use.
1. close the cover with the latches, making sure that the lower part of the
cover fits tightly against the hoover tank.
2. assemble the flexible suction hose by inserting it into the air inlet
opening located in the body of the hoover (fig. A, 3)
3. attach an extension tube to the other side of the flexible hose.
4. assemble a suitable suction nozzle onto the end of the tube.
The appliance is now ready for use.
7. Connecting to the mains
Before connecting the appliance to the power supply, ensure that the
supply voltage corresponds to the value indicated on the rating plate.
The power supply installation should comply with the essential
requirements for electrical installations and meet the safety requirements
for use. The parameters for the minimum cross-section of the supply cable
and the nominal value of the fuse, depending on the power of the
appliance, are given in the table below:
Unit power [W]
Minimum conductor
cross-section [mm2]
Minimum fuse type C
[A]
700-1400
1
10
The installation should be carried out by a qualified electrician. When
using extension cables, ensure that the conductor cross-section is not
smaller than required (see table). Arrange the electrical cable so that it is
not at risk of being cut during operation. Do not use damaged extension
cords. Periodically check the condition of the power supply cable. Do not
pull on the power cable.
8. Switching on the device
Before starting up the unit, it is essential to carry
out the steps described in the section ‘Preparing for
operation’.
There is an on/off switch on the lid of the hoover (Fig. A, 1). To switch on
the hoover, press the switch button into position I. To switch off the hoover,
press the switch button in the O position.
9. Operation of the device
When operating the device, all safety rules and
instructions described in the safety conditions
must be strictly observed..
The hoover is designed for use in domestic and commercial areas
(workshops, garages, etc.) The appliance is suitable for dry or wet
operation. The hoover is equipped with several types of brushes (Fig. D):
flat for cleaning larger floor areas, carpets: narrow for cleaning narrow
hard-to-reach areas (e.g. corners, crevices, etc.).
When cleaning wet dirt, please note that the machine is equipped with a
safety device that cuts off the suction of water into the motor. When
removing wet and damp dirt, equip the unit with a foam guard.
Blow-out function
Connect the flexible hose to the outlet socket. Switch on the hoover. Do
not direct air towards people or animals.
10. Ongoing maintenance
All maintenance must be carried out with the unit
unplugged.
Cleaning the dust container.
Remove dirt from the dust container frequently to avoid damage to the
appliance. Place the dust container (with the hoover lid removed) over a
bag or bin and dispose of the contents. When emptying the container of
dirty water, pour it down the drain.
Cleaning the filters
The fabric bag (filter) should be emptied and thoroughly shaken out. Rinse
the sponge filter under running water, allow to dry.
Storage
Store the cleaned, thoroughly dried hoover in the original box in a dry
place, out of the reach of children and bystanders.
Clean the entire power tool regularly, paying particular attention to
cleaning the ventilation openings of the power tool.
11. Spare parts and accessories
Accessories available for purchase:
DED66001 - paper bag, DED66101 - fabric filter (bag), DED66102 -
sponge filter.
For the purchase of spare parts and accessories, please contact the
Dedra Exim service. Contact details can be found on page 1 of the manual.
When ordering spare parts, please quote the batch number on the
nameplate together with the part number from the assembly drawing.
During the warranty period, repairs are carried out in accordance with the
terms of the warranty card. Return the faulty product for repair at the place
of purchase (the dealer is obliged to accept the faulty product), send it to
the central Dedra Exim service centre or to the service centre closest to
your place of residence (list of service centres at www.dedra.pl). Kindly
enclose the completed warranty card. After the warranty period has
expired, repairs are carried out by the central service. Send the defective
product to the service centre (shipping costs are paid by the user).
12. Trouble-shooting on your own
Disconnect the unit from the power supply before
attempting to troubleshoot the unit yourself.
PROBLEM
CAUSE
SOLUTION
Device does not switch
on
Incorrectly connected
power supply cable.
Carefully push the
power plug into the
socket
Unit does not switch on
Damaged power
supply cable.
Have the appliance
serviced
Unit does not switch on
No voltage.
Check the mains fuse.
Unit does not switch on
Defective switch.
Have the unit serviced.
Motor overheats,
suction power reduced.
Clogged air vents.
Clean the ventilation
openings.
Motor overheats,
suction power reduced.
Plugged flexible hose
or suction nozzle.
Remove blockage.
Motor overheats,
suction power reduced.
Clogged filter cover,
heavily soiled filter.
Check and clean the
filter.
Motor overheats,
suction power reduced.
Tank overfilled.
Empty the dirt
container.
Motor starts with
difficulty.
Clogged motor
bearings, dirty motor
fan.
Send the unit for
service.
13. Contents of the package
1. hoover DED6610 - 1 pc. 2. flexible hose 1.5 mb - 1 pc. 3. dusting brush
-1 pc. 4. plastic pipes -2 pcs. 5. sponge filter - 1 item. 6. fabric filter (bag)
- 1 item. 7. slot nozzle - 1 item. 8. paper bag - 1 item.
14 Information for users on the disposal of electrical
and electronic equipment (applicable to households)
The symbol on the products or accompanying documentation
indicates that defective electrical or electronic equipment must not
be disposed of with household waste. If you need to dispose of,
reuse or recover components, take them to a specialist collection
point where they will be accepted free of charge. Information on the
location of collection points for used equipment is provided by local
authorities, e.g. on their websites.
Bekijk gratis de handleiding van Dedra DED6612, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dedra |
| Model | DED6612 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 8128 MB |
