Dantherm HCV 700 handleiding
Handleiding
Je bekijkt pagina 43 van 60
43
INSTALLATION & SERVICE MANUAL FOR PROFESSIONALS
Maintenance and care: Troubleshooting
en
Troubleshooting
This section shows you how to recognize and understand possible operating errors.
For correct fault tracing Dantherm strongly recommends connecting a remote control or PC
with installed PC Tool or the Dantherm App, that works with the unit.
Errors are displayed on the HRC3 remote control with "E” + a number. The issue can then be
looked up in the troubleshooting overview and in the control panel manual to correct the
fault.
Operation warnings and faults are logged in the controller memory. Connect a computer
with PC Tool installed via USB to get detailed information from the log le.
Possible faults are shown on:
Appliance Signal
Unit Acoustic buzzer signal from the main PCB. Connect a remote tool or
PC Tool to view the specic error.
Filter reset LED
Handheld remote
control
Acoustic buzzer signal and display of a specic error code.
Wired remote con-
trol (HCP 10/11)
Audible buzzer signal and ashing LED.
The number of ashes corresponds to an error code followed by a
pause of 5 seconds.
See Airow direction in mode A/B.
PC Tool Display of error numbers and ability to log specic operation over a
longer period of time.
Smart phone app Display of a specic error code.
Errors shown on the display contain three numbers or letters. E.g. "E12” means error number
12.
How to read the error list:
Column Description Code Meaning
A
Number of ashes on the display (wired control) - -
B LED on membrane panel
Y Yellow LED ashes
R Red LED ashes
C Noise
0 No beep
1 One beep/hour
2 One beep/sec.
After completed inspection or repair of possible faults, the unit can be reset by disconnect-
ing/reconnecting the 230 V AC power supply. This resets the controller and the unit starts
normal operation and also restarts a new search for possible errors.
This can take up to 15 minutes.
Introduction
Error messages on
the remote control
LCD panel
PC Tool
Error signalling
Error list
Resetting errors
Bekijk gratis de handleiding van Dantherm HCV 700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dantherm |
| Model | HCV 700 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4620 MB |
