Danby WUF170W handleiding
Handleiding
Je bekijkt pagina 4 van 36
3
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a floor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for indoor household
and garage use only. It is not designed for
outside installation, including anywhere that
is not temperature controlled such as porches,
vehicles, etc.
• Before connecting the appliance to a power
source, let it stand upright for approximately
24 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• Allow 10 cm (3.9 inches) of space between the
sides and top of the appliance, 7.6cm (3 inches)
of clearance at the back of the appliance.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
GARAGE READY
This freezer is Garage Ready! It is intended for
indoor household and garage use. Freezers are
tested to perform in temperatures ranging from
-17 to 43°C / 0 to 110°F. It is not designed for
outside installation, including anywhere that is not
temperature controlled.
FEATURES
1. Refrigerator/Freezer Control
2. Shelves (4)
3. Drawer
4. Leveling feet (2 front) and Wheels (2 front, 2
rear)
5. Door bins (4)
INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS
LEVELING INSTRUCTIONS
There are two adjustable legs on the bottom front
of the appliance that can be turned up or down to
ensure that the appliance is level.
1. Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the chassis.
2. Slowly turn the leveling leg clockwise until the
appliance is level.
1
2
3
4
5
ON FIRST POWER UP
The default setting is “Energy Saving Freeze”
mode with the default setting temperature of -18°C
(64.4°F).
Bekijk gratis de handleiding van Danby WUF170W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Danby |
| Model | WUF170W |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4001 MB |
