Danby DRC12B1DBD handleiding
Handleiding
Je bekijkt pagina 14 van 36
13
OPERATING INSTRUCTIONS
HOUSEKEEPING SAFETY LOCK
• The controls will respond to touch, so you do not
need to apply pressure
• This active Housekeeping Safety Lock function
allows you to lock the controls to prevent
unintended use (ex. children accidentally turning
the cooking zones on)
To lock the controls
• Touch the Safety Lock control button once
• The timer indicator will show “Lo”, and the
Safety Lock function will be active
To unlock the controls
• Ensure the cooktop is turned on
• Touch and hold the Safety Lock control button
for 3 seconds
• The buzzer will beep once and “Lo” will
disappear from the timer indicator
• This means the Safety Lock has been deactivated
and you may now start using the cooktop
Caution
• When this function in enabled, all touch control
buttons are disabled except for the ON/OFF
button and the Safety Lock control button
• You can always turn off the cooktop using the
ON/OFF button in an emergency, but the
next time you operate the cooktop you will need
to unlock it
Note:
• Under the Safety Lock function, if you turn on the
cooktop without disabling the Safety Lock, then
the next time you turn it on it will still be active
STOP & GO FUNCTION
• This function can turn off all zones in case you
need to step out of the kitchen while cooking
(doorbell, phone rings, etc)
To activate the stop & go function
• Press the Stop & go function button once
• This will put a hold on all programmed settings
and the cooktop will stop heating
• When on, all heat setting indicators will display
“P”
To deactivate the stop & go function
• Once you return, press the Stop & go function
button again
• This will remove the hold on all settings, and
they will return to what the were previously
• The “P” will disappear from all indicators
Note
• When the Stop & Go function is active, all
control buttons are disabled, except for the ON/
OFF and Stop & Go button
• If the Stop & Go function is enabled for more
than 10 minutes, the cooktop with automatically
turn off
TIMER FUNCTION
Minutes display
Timer control
• Timer function has two different settings:
1. Minute Minder
2. Auto Off
• Default setting is 30 minutes
• If you press and hold down either / button
when setting the timer, the value will go up and
down rapidly
• After adjusting the timer the display will flash
for 5 seconds. Once it stops, the time has been
confirmed and the timer has begun
Bekijk gratis de handleiding van Danby DRC12B1DBD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Danby |
| Model | DRC12B1DBD |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3185 MB |
