Handleiding
Je bekijkt pagina 16 van 52
16
OPERATING INSTRUCTIONS
USE OF PRODUCT
USE OF GAS BURNERS
Ignition of the burners
The position symbol above each control knob
indicates the burner that the knob controls.
Manual ignition of the gas burners
If your appliance is not equipped with an ignition
aid, or in case there is a failure in the electric
network, follow the procedures listed below.
For hob burners: Push in the knob of the burner
you wish to ignite and keep it pressed while turning
it anti-clockwise until the knob is in the ‘maximum’
position. Continue pressing the knob and hold a
lit match, taper or other manual aid to the upper
circumference of the burner. Move the ignition
source away from the burner as soon as you see a
stable flame.
For oven burner: Push in and turn the oven
control knob anti-clockwise until the knob is in the
‘maximum’ position. Hold a lit match, taper or other
manual aid to to the ignition hole that is located on
the front left corner of the burner. Move the ignition
source away as soon as you see a stable flame.
Electrical ignition by control knob
Push in the knob of the burner you wish to ignite
and keep it pressed while turning it anti-clockwise
until the knob is in the 90 degrees position. The
microswitch under the knob will create sparks
through the spark plug for as long as the control
knob is pressed. Press the knob until you see a
stable flame on the burner.
Flame safety device
Hob burners
Hobs equipped with a flame failure device provide
security in case of an accidentally extinguished
flame. For this reason, during ignition, keep the
knob pressed until you see stable flames.
Hold down the control for approximately 10 to
15 seconds after the burner has lit. Releasing the
control too soon will extinguish the flame. If such a
case occurs, the device will block the burners gas
lines and will avoid any accumulation of unburned
gas. Wait 90 seconds before re-igniting an
extinguished gas burner.
Oven / Grill (If available) Burners
Regardless of the model of your appliance, all oven
burners are equipped with a gas safety device. For
this reason, during ignition, keep the oven knob
pressed until you see stable flames.
Hold down the control for approximately 10 to
15 seconds after the burner has lit. Releasing the
control too soon will extinguish the flame.
If the flames are cut out after you release the knob,
repeat the ignition procedure. If the oven burner
does not ignite afteryou keep the burner knob
pressed for 30 seconds, open the oven door and do
not attempt re-ignition for at least 90 seconds. If the
oven flames go out accidentally, repeat the same
procedure.
HOB CONTROLS
Hob burner
The knob has 3 positions: off (0), maximum (big
flame symbol) and minimum (small flame symbol).
Ignite the burner with the knob in the ‘maximum’
position; you can then adjust the flame length
between the ‘maximum’ and ‘minimum’ positions.
Do not operate the burners when the knob is
between the “maximum” and “off ” positions.
OFF Position
MAX Position
MIN. Position
MODULATE
Bekijk gratis de handleiding van Danby DR24V1WH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Danby |
| Model | DR24V1WH |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 6271 MB |