Handleiding
Je bekijkt pagina 4 van 54
D-EOMZC00204-18_04EN 4/54
1 SAFETY CONSIDERATIONS
1.1 General
Installation, start-up and servicing of equipment can be hazardous if certain factors particular to the installation are not
considered: operating pressures, presence of electrical components and voltages and the installation site (elevated plinths
and built-up up structures). Only properly qualified installation engineers and highly qualified installers and technicians,
fully trained for the product, are authorized to install and start-up the equipment safely.
During all servicing operations, all instructions and recommendations, which appear in the installation and service
instructions for the product, as well as on tags and labels fixed to the equipment and components and accompanying parts
supplied separately, must be read, understood and followed.
Apply all standard safety codes and practices.
Wear safety glasses and gloves.
Use the proper tools to move heavy objects. Move units carefully and set them down gently.
1.2 Avoid electrocution
Only personnel qualified in accordance with IEC (International Electrotechnical Commission) recommendations may be
permitted access to electrical components. It is particularly recommended that all sources of electricity to the unit be shut
off before any work is begun. Shut off main power supply at the main circuit breaker or isolator.
IMPORTANT: This equipment uses and emits electromagnetic signals. Tests have shown that the equipment
conforms to all applicable codes with respect to electromagnetic compatibility.
RISK OF ELECTROCUTION: Even when the main circuit breaker or isolator is switched off, certain
circuits may still be energized, since they may be connected to a separate power source.
RISK OF BURNS: Electrical currents cause components to get hot either temporarily or
permanently. Handle power cable, electrical cables and conduits, terminal box covers and motor
frames with great care.
In accordance with the operating conditions the fans can be cleaned periodically. A fan can start at
any time, even if the unit has been shut down.
1.3 Safety Devices
Each unit is equipped with safety devices of three different kinds:
• Emergency Stop
• Overcurrent/Overload Protections
• Overtemperature Protections
• Phase reversal, under/over voltage, ground fault protections
• Phase reversal, under/over voltage, ground fault protections
• Freezing protection
• High Pressure Protection
• Low Pressure Protection
• Mechanical High Pressure Switch
• Relief Safety Valve
• Inverter fault auto diagnostic
The emergency stop causes all motors to stop, but does not switch off power to the unit. Do not
service or operate on the unit without having switched off the main switch.
Do not operate on a faulty fan before the main switch has been shut off. Overtemperature protection
is auto-reset, therefore a fan may restart automatically if temperature conditions allow it.
Direct intervention on the power supply can cause electrocution, burns or even death. This action
must be performed only by trained persons.
Bekijk gratis de handleiding van Daikin EWYS5004Z, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Daikin |
| Model | EWYS5004Z |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 7564 MB |
