Handleiding
Je bekijkt pagina 10 van 52
D-EIMHP01405-21_11EN 10/52
4 MECHANICAL INSTALLATION
4.1 Safety
Before installation and commissioning of the machinery, the people involved in this activity must have acquired the
information necessary to perform these tasks, applying all the information gathered in this manual. In particular:
• the unit must be firmly anchored to the ground when it must not be moved
• the unit can only be lifted using the lifting points indicated by labels fixed to its base;
• always protect operating personnel with personal protective equipment appropriate to the activities to be
performed. The individual devices commonly used are: helmet, glasses, gloves, headphones, safety shoes.
Further personal and collective protection devices must be adopted after having carried out an adequate
analysis of the specific risks in the relevant area, according to the activities to be carried out.
4.2 Handling and lifting
Avoid bumping and/or jolting during loading/unloading unit from the truck and moving it. Do not push or pull the unit from
any part other than the base frame. Secure the unit inside the truck to prevent it from moving and causing damages. Do
not allow any part of the unit to fall during transportation or loading/unloading.
Lifting instructions:
Equipment, ropes, lifting accessories and handling procedures must comply with local regulations and current legislation.
When lifting the machine, use only the holes in the frame identified in the figure. Use lifting hooks with closing device
exclusively. The hooks must be safely fastened before performing the handling.
The ropes and hooks used must have an appropriate capacity for the load. Refer to the plate on the unit for the weight
of the specific machine.
Lifting ropes must have the minimum length shown in the diagram. All units of the series are supplied with lifting points
indicated by labels. Only these points may be used for lifting the unit, as shown in the following figures.
The installer has the responsibility to ensure the selection and correct use of the lifting equipment.
Alternatively, the machine may be moved with a forklift, as shown. When lifting the machine, make sure it is levelled
properly so it will not overturn.
4.2.1 Lifting the MONO unit
The machine must be lifted slowly and well levelled. Always use protective devices to prevent damage to the belt and
note the position of the unit’s centre of gravity. Adjust the lifting equipment if necessary to ensure that the unit is level led.
The unit(s)- both Mono and Dual- can be lifted, using the buttonholes in the base, by:
• lifting straps
• forklift, where the dimensions of the forks permit.
N.B.: Follow the lifting instructions provided in the ID plate fastened to the electrical panel.
Figure 1 – Lifting the MONO unit
Bekijk gratis de handleiding van Daikin EWAT016CZP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Daikin |
| Model | EWAT016CZP |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 9712 MB |
