Dahua Technology N83BP83 handleiding
Handleiding
Je bekijkt pagina 60 van 241
Operation Manual
46
Parameter Description
ARP/Ping
Click to enable ARP/Ping to set IP address service. Get the
camera MAC address, and then you can change and configure the
device IP address with ARP/ping command.
This is enabled by default. During restart, you will have no more
than 2 minutes to configure the device IP address by a ping
packet with certain length, the server will be turned off in 2
minutes, or it will be turned off immediately after the IP address
is successfully configured. If this is not enabled, the IP address
cannot be configured with ping packet.
A demonstration of configuring IP address with ARP/Ping.
1. Keep the camera that needs to be configured and the PC
within the same local network, and then get a usable IP
address.
2. Get the MAC address of the camera from device label.
3. Open command editor on the PC and enter the following
command.
4. Restart the camera.
5. Check the PC command line, if information such as Reply from
192.168.0.125…is displayed, the configuration succeeds, and
you can turn it off then.
6. Enter http://(IP address) in the browser address bar to log in.
NIC
Select the Ethernet card that need to be configured, and the
default one is Wire.
Mode
The mode that the camera gets IP:
●
Static: Configure IP Address, Subnet Mask, and Default
Gateway manually, and then click Save, the login page with
the configured IP address is displayed.
●
DHCP: When there is DHCP server in the network, select
DHCP, and the camera acquires IP address automatically.
MAC Address Displays host MAC address.
Bekijk gratis de handleiding van Dahua Technology N83BP83, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dahua Technology |
| Model | N83BP83 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 39346 MB |
