D-Link DPS-PWR740AC handleiding
Handleiding
Je bekijkt pagina 28 van 69
DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
28
Power On (AC Power)
Plug one end of the AC power cord into the power socket of the Switch and the other end into the local power source
outlet. After the system is powered on, the power LED will light up green to indicate that the system has been powered
up.
Power Failure (AC Power)
In the event of a power failure, just as a precaution, unplug the power cord from the Switch. After the power returns,
plug the power cord back into the power socket of the Switch.
Installing Power Cord Retainer
To prevent accidental removal of the AC power cord, it is recommended that you install the power cord retainer
together with the power cord. Note that this section is only applicable to DMS-3130-30TS.
1. With the rough side facing down, insert the tie wrap into the hole below the power socket.
Figure 3-9 Insert Tie Wrap into the Switch
2. Plug the AC power cord into the power socket of the Switch.
Figure 3-10 Connect the power cord to the Switch
3. Slide the retainer through the tie wrap until the end of the cord.
Bekijk gratis de handleiding van D-Link DPS-PWR740AC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DPS-PWR740AC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10019 MB |
