D-Link DPS-PWR740AC handleiding

Niet gecategoriseerd

D-Link

69 pagina's

PDF beschikbaar

Handleiding

DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide 
23 
3.  Installation 
This chapter covers the installation guidelines and steps and procedures of D-Link DMS-3130 Series switches.  
 
Installation Guidelines 
Installing the Switch without a Rack 
Installing the Switch in a Standard 19" Rack 
Installing Transceivers into the Transceiver Ports 
Power On (AC Power) 
Connecting PoE BT to the switch 
Installing the Redundant Power Supply (RPS) 
Installing the RPS into a Rack-mount Chassis 
Installation Guidelines 
This section will discuss the hardware installation guidelines that the user must follow to install this switch properly and 
safely into the appropriate environment. 
Visually inspect the power cord and check if it is fully secured to both the power connector, on the Switch, and the 
electrical outlet that supplies power. 
Install the Switch in a cool and dry place within the acceptable operating temperature and humidity ranges. For more 
information about the acceptable operating temperature and humidity ranges, refer to the Physical and Environmental 
section. 
Install the Switch in a site free from strong electromagnetic field generators such as motors, vibration, dust, and direct 
exposure to sunlight. 
 
Installing the Switch without a Rack 
This section is intended to guide the user through installing the Switch in an area other than a switch rack. Firstly, 
attach the included rubber feet to the bottom of the Switch. Then, look for the marked blocks on the bottom of the 
Switch for attaching the rubber feet. These markings are usually found at each corner on the bottom of the device. 
The rubber feet help cushion the Switch, further protecting the casing from scratches and also preventing it from 
scratching other surfaces. 
 
 
Figure 3-1 Attaching rubber feet to the Switch  
 
Install the Switch on a sturdy, level surface that can support the weight of the Switch (see the Weight section in 
Appendix A - Technical Specifications.). Do not place any heavy objects on the Switch. The power outlet should be 
within 1.82 meters (6 feet) distance to the Switch. Make sure that there is proper and adequate heat dissipation and 
ventilation from and around the Switch. Leave at least 10 cm (4 inches) of space at the front, sides, and rear of the 
Switch for ventilation. 

Bekijk gratis de handleiding van D-Link DPS-PWR740AC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.