D-Link DGS-6600-PWR handleiding
Handleiding
Je bekijkt pagina 364 van 761
DGS-6604 m/ mSW Rls. 1.00.029 neighbor timers
CLI Reference Guide
333
neighbor timers
Use this command to set the timers for a specific BGP peer or peer group. Use
the no form of this command to clear the timers for a specific BGP neighbor.
neighbor { IP-ADDRESS | PEER-GROUP-NAME} timers KEEP-ALIVE HOLD-TIME
no neighbor { IP-ADDRESS | PEER-GROUP-NAME} timers
Default KEEPALIVE: 60 seconds
HOLDTIME: 180 seconds
Command Mode Router configuration
Usage Guideline The timers configured for a specific neighbor, or peer group, override the timers
configured for all BGP neighbors using the timers bgp command.
Example The following example shows how to configure the KEEP-ALIVE timer to 120
seconds and the HOLD-TIME timer to 360 seconds for the neighbor
172.16.10.10:
Verify the settings by entering the show ip bgp neighbor command.
Syntax Description
IP-ADDRESS Specifies IP address prefixes.
PEER-GROUP-NAME Name of a Border Gateway Protocol (BGP) peer group.
KEEP-ALIVE The frequency (in seconds) that specifies how often the switch sends keepalive
messages to its peer. The default is 60 seconds. The range is from 0 to 65535.
HOLD-TIME The elapsed time (in seconds) after not receiving a keepalive message that the
software declares a peer dead. The default is 180 seconds. The range is from 0
to 65535.
Switch(config)# router bgp 65100
Switch(config-router)# neighbor 172.16.10.10 timer 120 360
Bekijk gratis de handleiding van D-Link DGS-6600-PWR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DGS-6600-PWR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 52758 MB |
Caratteristiche Prodotto
| Kleur van het product | Grijs |
| Breedte | - mm |
| Diepte | - mm |
| Hoogte | - mm |
| Geluidsniveau | - dB |
