D-Link DGS-6600-PWR handleiding
Handleiding
Je bekijkt pagina 306 van 761
DGS-6604 m/ mSW Rls. 1.00.029 ipv6 ospf transmit delay
CLI Reference Guide
275
ipv6 ospf transmit delay
To set the estimated time required to send a link-state update packet on the
interface, use the ipv6 ospf transmit-delay command. To return to the default
value, use the no form of this command.
ipv6 ospf transmit-delay SECONDS [instance-id INSTANCE-ID]
no ipv6 ospf transmit-delay [instance-id INSTANCE-ID]
Default SECONDS: 1
INSTANCE-ID: 0
Command Mode Interface configuration
Usage Guideline Before being transmited, Link-State Advertisements (LSAs) in the update packet
must have their ages incremented by the amount specified in the seconds. The
value assigned should take into account the transmission and propagation
delays for the interface.
If the delay is not added before transmission over a link, the time in which LSAs
propagate over the link will not be considered. This setting has more significance
on very low-speed links.
Example The following example sets the transmit delay value to 3 seconds.
Syntax Description
SECONDS The interval the router waits before it transmits a packet. The valid setting is 1-
65535.
INSTANCE-ID (Optional) Instance identifier. To change this ID, configure the "no" command
first. The valid setting is from 0 to 255.
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if)# ipv6 ospf transmit-delay 3
Bekijk gratis de handleiding van D-Link DGS-6600-PWR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DGS-6600-PWR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 52758 MB |
Caratteristiche Prodotto
| Kleur van het product | Grijs |
| Breedte | - mm |
| Diepte | - mm |
| Hoogte | - mm |
| Geluidsniveau | - dB |
