D-Link DGS-6600-PWR handleiding
Handleiding
Je bekijkt pagina 304 van 761
DGS-6604 m/ mSW Rls. 1.00.029 ipv6 ospf retransmit-interval
CLI Reference Guide
273
ipv6 ospf retransmit-interval
This command specifies the time between link-state advertisement (LSA)
retransmissions for adjacencies belonging to an interface.
ipv6 ospf retransmit-interval SECONDS [instance-id INSTANCE-ID]
no ipv6 ospf retransmit-interval [instance-id INSTANCE-ID]
Default Seconds: 5
INSTANCE-ID: 0
Command Mode Interface configuration
Usage Guideline After sending an LSA to a neighbor, the router keeps the LSA until it receives an
acknowledgement. In case the router does not receive an acknowledgement,
during the set time (the retransmit interval value), it retransmits the LSA. Set the
retransmission interval value conservatively to avoid needless retransmissions.
The interval should be greater than the expected round-trip delay between two
routers.
Example The following example sets the retransmit interval value to 6 seconds.
Syntax Description
SECONDS The interval the router waits before it retransmits a packet. The valid setting is 1-
65535.
INSTANCE-ID (Optional) Instance identifier. In order to change this ID, configure the "no"
command first. The valid setting is from 0 to 255.
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if)# ipv6 ospf retransmit-interval 6
Bekijk gratis de handleiding van D-Link DGS-6600-PWR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DGS-6600-PWR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 52758 MB |
Caratteristiche Prodotto
| Kleur van het product | Grijs |
| Breedte | - mm |
| Diepte | - mm |
| Hoogte | - mm |
| Geluidsniveau | - dB |
