CYP PUV-1660TTX handleiding
Handleiding
Je bekijkt pagina 16 van 52
11
- Power On: Turn on the connected HDMI display device.
- Power Off: Turn off the connected HDMI display device.
- Active Source: Force the connected HDMI display device to
switch to the HDMI input that this unit is connected to.
- Power On + Active Source: Turn on the connected HDMI display
device and force the connected HDMI display device to switch to
the HDMI input that this unit is connected to.
Note: Not all HDMI devices support all CEC commands.
3) RS232: Enable or disable sending an RS-232 command when the
currently selected Automation Event is activated. Click the “Edit” icon (
) to configure the various RS-232 port settings including baud rate, data
length, parity and stop bits.
Note: RS-232 Automation commands will be output via the RS-232 port
located on the connected receiver.
Delay: Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined RS-232 command.
Wait: Set the length of time, in seconds, to wait after this
Automation Event has been activated before ANY other Automation
Event can be detected.
RS232 Command: Displays the currently defined RS-232 command
text. Click on the “Edit” icon (
) to define the RS-232 command to
send when the specified Automation Event is activated. Click the
“Test” button to send the command immediately.
Bekijk gratis de handleiding van CYP PUV-1660TTX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | PUV-1660TTX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3764 MB |
