CYP PUV-1650RX handleiding
Handleiding
Je bekijkt pagina 63 van 92
63
Note: Before creating new Events, please be sure that all required macros,
commands and devices have already been defined.
-
Active: Displays the active state of each Event. Events that have
Active set to “OFF” cannot be triggered.
-
Event Name: Displays each Event’s name.
-
Event Type: Displays the type of trigger/interface that is being
watched to activate an Event. Event types include: Input, Output,
System Command, Serial Port, TCP/IP, IR Receiver, External Trigger,
and Schedule.
-
Event Condition: Displays the condition, if applicable for the selected
Event Type, required to trigger the Event. Examples of conditions are:
Low, High, Falling, Raising, Both Edge, or a Command.
-
Event Mode: Displays the currently selected behavior for the Event.
Events can have one of the following mode types.
-
Once: The Event’s macro is run one time when triggered and
then will not be activated again. If the unit is rebooted, all “Once”
Events will become active again.
-
Single: The Event’s macro is run a single time each time the
Event is triggered.
-
Repeat: The Event’s macro is repeatedly run a pre-determined
number of times (up to 255) each time the Event is triggered. A
delay time between each repeat can be set.
Bekijk gratis de handleiding van CYP PUV-1650RX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | PUV-1650RX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6863 MB |
