CYP PUV-1350PL-KIT handleiding
Handleiding
Je bekijkt pagina 31 van 84
25
Wait: Set the length of time, in seconds, to wait after this
Automation Event has been activated before ANY other Automation
Event can be detected.
IR Command: Shows the IR command (in ASCII hex pairs) that will
be sent when the specified Automation Event is activated. Click the
“Edit” icon ( ) to learn the command from an IR remote. Click the
“Test” button to send the command immediately.
3) CEC: Enable or disable sending a CEC command when the currently
selected Automation Event is activated.
Note: CEC support must also be enabled on the connected HDMI display
device.
Delay: Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined CEC command.
Wait: Set the length of time, in seconds, to wait after this
Automation Event has been activated before ANY other Automation
Event can be detected.
CEC Command: Set the CEC command to send when the specified
Automation Event is activated. Click the “Test” button to send the
command immediately. Available CEC commands are:
- Power Off: Turn off the connected HDMI display device.
- Power On: Turn on the connected HDMI display device.
- Active Source: Force the connected HDMI display device to
switch to the HDMI input that this unit is connected to.
Note: Not all HDMI devices support all CEC commands.
4) RS232: Enable or disable sending an RS-232 command when the
currently selected Automation Event is activated. Click the “Edit” icon
(
) to configure the RS-232 port.
Bekijk gratis de handleiding van CYP PUV-1350PL-KIT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | PUV-1350PL-KIT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5989 MB |
