CYP PRO-F32M handleiding
Handleiding
Je bekijkt pagina 13 van 28
13
COMMAND DESCRIPTION AND PARAMETERS
HDMIOUTSCALE ? Show the current HDMI output scaler mode.
IPCONFIG Show the current IP configuration.
SETIP N1 N2 N3 Set the IP Address, Netmask, and Gateway for
the unit when in Static IP mode with a single
command. Disables DHCP.
N1 = X.X.X.X [X = 0 ~ 255, IP Address]
N2 = X.X.X.X [X = 0 ~ 255, Netmask]
N3 = X.X.X.X [X = 0 ~ 255, Gateway]
SIPADDR N1 Set the IP Address. Disables DHCP.
N1 = X.X.X.X [X = 0 ~ 255]
SNETMASK N1 Set the Ethernet netmask. Disables DHCP.
N1 = X.X.X.X [X = 0 ~ 255]
SGATEWAY N1 Set the Ethernet gateway. Disables DHCP.
N1 = X.X.X.X [X = 0 ~ 255]
RSTIP Reset the unit’s Ethernet mode to DHCP.
ECHO N1 Enable or disable echo when using the console.
Available values for N1:
0 [Off ]
1 [On]
ECHO ? Show the current console echo state.
FADEFAULT Reset the unit to the factory defaults.
VER Show the unit’s current firmware version.
REBOOT Reboot the unit.
ETH_FADEFAULT Reset all Ethernet settings to the factory
default.
Note: Commands will not be executed unless followed by a carriage return.
Commands are not case-sensitive.
Bekijk gratis de handleiding van CYP PRO-F32M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | PRO-F32M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2040 MB |
