CYP OR-32USBC-4K22 handleiding
Handleiding
Je bekijkt pagina 17 van 64
12
6.4.3 Automation Tab
This tab provides control over the unit’s automatic control command
broadcast behavior when any of the specified Automation Events occur.
Automation commands can control connected devices via CEC, RS-232,
and Telnet.
Note: CEC events are only sent to the device connected to HDMI output A.
1) Event: Use the dropdown to select the Automation Event to configure.
Available Automation Events are:
- Power On: This unit is powered on.
- Out A Source Active: The currently selected input changes from
inactive to active.
- Out A Source Lost: The currently selected input changes from
active to inactive.
2) CEC: Enable or disable sending a CEC command when the currently
selected Automation Event is activated.
Note: CEC support must also be enabled on the device connected to HDMI
output A.
Delay: Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined CEC command.
Wait: Set the length of time, in seconds, to wait after this
Automation Event has been activated before ANY other Automation
Event can be detected.
Bekijk gratis de handleiding van CYP OR-32USBC-4K22, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | OR-32USBC-4K22 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4396 MB |
