CYP IP-CS7 handleiding
Handleiding
Je bekijkt pagina 22 van 68

17
Stop Stream: To stop the Line In audio stream on a single receiver,
drag the receiver down to the “Stop” button at the bottom of
the window, then release the mouse button. To stop these audio
streams on ALL receivers, drag the “All” button down to the “Stop”
button.
5) Mic In Audio Routing: Provides drag-and-drop control over the
independent routing of Mic In audio between all compatible
transmitters and receivers.
Note: If linked routing for audio is enabled on the target receiver, then all
other linked routing enabled streams will also switch. See section 6.6.5 for
linked routing settings.
Mic In Audio Transmitter: This section provides drag-and-drop
buttons for all transmitters with Mic In audio detected by the
system.
Source to Single Receiver Routing: To route a transmitter’s Mic
In audio stream to a receiver, click and drag the source’s button on
the left to the preferred receiver on the right side, then release the
mouse button. If the routing was completed successfully, the newly
routed source’s name will appear below the receiver’s name within
the button. Clicking on any source button will change the colour of
itself, and all currently routed receivers.
Note: Receivers may also be drag and dropped onto sources to activate
a new route.
Source to Multiple Receiver Routing: To route a transmitter’s
Mic In audio stream to multiple receivers at the same time, click
and drag the source’s button on the left to a Group button or the
“All” button on the right side, then release the mouse button. If the
routing was completed successfully, the source’s name will appear
within all appropriate buttons.
Bekijk gratis de handleiding van CYP IP-CS7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | CYP |
Model | IP-CS7 |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 6620 MB |