CYP IP-A750TX handleiding
Handleiding
Je bekijkt pagina 16 van 32
11
same channel will receive audio from this transmitter. The available
channel range is from 0 to 255.
Note: Every transmitter within the same local network must be assigned a
dierent broadcast channel in order to avoid conicts.
2) IP Setup: This section allows for conguration of the IP acquisition
mode and Ethernet settings of the unit. It also provides an easy way to
nd the physical unit when installed with many other similar units.
IP Mode & Settings: The IP mode may be switched between “Auto
IP”, “DHCP” or “Static IP”. When the unit is set to Auto IP mode it
will automatically assign itself an APIPA address from the 169.254.
xxx.xxx range. When the unit is set to DHCP mode it will attempt
to automatically obtain an IP address from a DHCP server. When
the IP mode is set to static IP, you can manually set the IP address,
netmask and gateway address. Click the “Apply” button to save
changes made to the IP Mode or Conguration.
Note: The default network setting for this unit is “Auto IP”.
Find Your Device: Selecting “Show Me” will cause the unit to
immediately begin ashing the PWR and LINK LEDs on the front
of the unit to make it easy to nd. Selecting “Hide Me” returns
the LEDs to their normal behavior. This setting is useful when
troubleshooting an installation with a large number of units in a
rack.
3) Casting Mode: Allows for the selection of the broadcasting mode
used by the transmitter. Click the “Apply” button to save changes
made to the broadcasting mode.
Note: Receivers must be set to the same mode as the linked transmitter in
order to receive audio.
Multicast: This mode sends a single audio stream that can be
played simultaneously by multiple receivers without increasing
bandwidth usage. This mode is ideal for matrixing scenarios.
Note: Multicast mode requires a network switch with IGMP snooping
enabled.
Unicast: This mode uses a discrete audio stream for every
connected receiver and is ideal for simple, point-to-point, streaming
setups. This mode uses considerably more bandwidth than Unicast
mode when multiple receivers are being used, however it does not
require a network switch that supports IGMP snooping.
Bekijk gratis de handleiding van CYP IP-A750TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | IP-A750TX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2131 MB |
