CYP IP-7050RX-TG handleiding
Handleiding
Je bekijkt pagina 19 van 48
14
When saving changes on the Video Wall tab, remember to select the
appropriate “Apply To:” target unit before pressing the “Apply” button. To
make changes to the unit you are currently connected to, select “This”
as the target. Otherwise, select the IP address of the receiver (client) you
want to apply changes to from the “Apply To:” drop down or select “All” to
send the changes to all receivers in the group.
Note: While it is possible to create small video walls using unicast mode, in
order to more efficiently use the available network bandwidth, it is strongly
recommended to only use multicast mode when creating video walls.
1) Bezel and Gap Compensation: This section of the Video Wall tab
is used to define the physical dimensions of each display being
used in the video wall. Accurate measurements are needed of the
monitor’s outer frame (OW, OH) and the video screen (VW, VH). The
measurements may be made using any unit format (inches, mm, cm,
etc.) as long as ALL measurements in the same wall are made using
the exact same units and the numbers are integers.
OW (Outer Width): This is the horizontal measurement of the
display’s outer case.
OH (Outer Height): This is the vertical measurement of the
display’s outer case.
VW (Video Width): This is the horizontal measurement of the
display’s video screen.
VH (Video Height): This is the vertical measurement of the display’s
video screen.
Bekijk gratis de handleiding van CYP IP-7050RX-TG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | IP-7050RX-TG |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3740 MB |
